Advertisement
Street Wrap
Installation Guide
Installation
NOTE: There are no pre-drilled holes in the aluminum extrusion, please drill
holes accordingly to meet field requirements, using the appropriate screw.
Aluminum
extrusion
Mounting
clips
Mounting Accessories
Warnings
Lighting surface
Street Wrap Flex Back-Bend
only bends as shown above.
TOP VIEW
For assembly of Street Wrap Flex Back-Bend longer than 6.6 ft (2 m):
Careful handling with a minimum of two (2) employees is required.
Customer service and technical support
SloanLED Headquarters
3490 Venture Dr., San Angelo, TX, USA
325 227 4577 • info@SloanLED.com
SloanLED.com
P/N 403150-BB Rev A 2024-02-15
Flex Back-Bend
™
Finish
clips
1. Drill screw hole and install mounting
accessories with screws provided.
Mounting
SIDE VIEW
SloanLED Europe b.v.
Argonstraat 110, 2718 SN Zoetermeer, NL
+31 88 12 44 900 • Europe@SloanLED.com
Do not
pull on
or hold
product by
cable.
Do not twist or bend product at sharp angles.
surface
2. Gently press product into
mounting accessories.
PAGE 2 OF 2
Advertisement
