Advertisement
Street Wrap
Installation Guide
Cutting and Sealing
Insert
Installation tools & components
1. Cut on designvated cut mark.
3. Install silicone insert after cut.
Flex Back-Bend
™
End
Silicone
cap
glue
2. Clean cut end before next steps.
4. Apply silicone glue to silicone end
cap, making sure that cut section is
completely sealed.
CAUTION
Do NOT twist and
bend this product
abruptly or severely.
This action may
Pipe
cause copper trace or solder
cutter
connections to crack, resulting in
section outages along the strand.
TAKE EXTREME CAUTION WHEN
Unwind Flex strip from coil or reel
STOP
UNBOXING AND INSTALLING.
Normal flex
Unnatural bend
Section outage
Result of twist & bend
Outages caused by these actions
may void your warranty.
carefully and without twisting.
PAGE 1 OF 2
Advertisement
Table of Contents
Related Manuals for Principal LED SloanLED Street Wrap Flex Back-Bend
Summary of Contents for Principal LED SloanLED Street Wrap Flex Back-Bend
- Page 1 Street Wrap Flex Back-Bend ™ Installation Guide Cutting and Sealing CAUTION Do NOT twist and STOP bend this product abruptly or severely. This action may Insert Silicone Pipe cause copper trace or solder glue cutter connections to crack, resulting in section outages along the strand.
- Page 2 Street Wrap Flex Back-Bend ™ Installation Guide Installation NOTE: There are no pre-drilled holes in the aluminum extrusion, please drill holes accordingly to meet field requirements, using the appropriate screw. Aluminum extrusion Finish clips Mounting clips 1. Drill screw hole and install mounting 2.
Need help?
Do you have a question about the SloanLED Street Wrap Flex Back-Bend and is the answer not in the manual?
Questions and answers