Advertisement
ADDITIONAL OUTPUT INFORMATION
•
Each of the Output functions offers the availability
of monitoring a Normally Open or a Normally
Closed Dry contact.
•
Each contact's state will change to follow the status
of the monitored function.
•
To combine multiple outputs, connect N/O contacts
in parallel, or N/C contacts in series.
See diagrams at right. The use of any/all Outputs
is optional.
•
If power is removed from the CX-DA400, each contact in it's normal
state (powered), will change state. Example: Door Status will appear as
if the door
has been opened; Alarm and Bypass contacts will appear as if an alarm
or bypass condition exists.
7
ADDITIONAL FEATURES
SEE COMPONENT LOCATION DIAGRAM ON PAGE 2
TROUBLE SHOOTING TIPS
• Horn won't Reset - Verify Tamper Switch is closed; Verify
Door Supervision Jumper is correct for application; Check
Door Contact Resistors are installed as per Step 1 if Door
Supervision is enabled.
• LED always Green - Normal condition when Jumper 4 is OFF;
Verify Shunt Contact & Voltage Sense jumpers are correct for
your application; Verify Key Switch is Vertical and Bypass Input
is open.
• Alarm when Door Opens - Verify that SO&S1 Jumpers and
Silent Time are set greater than 0 sec.; Verify Intrusion Jumper
is set correctly for application.
• Clicking Output Relays - Verify Jumper 6 (Reserved) is OFF.
CX-DA400 Door Prop Alarm Installation Instructions
BYPASS TS1
(9&10) input, to
N/O contact to
remotely Bypass or
Reset the unit.
Voltage Sense
Shunt Input
Bypass Input
Door Input
Output Relays
• The CX-DA400 mounts flush in a 2.5" (63 mm) deep, 2-Gang
ELECTRICAL SPECIFICATIONS
VOLTS
12-24 VAC/DC
Power
12-24 VAC/DC
Dry Contact
Dry Contact
Dry Contact
Dry Contact
MECHANICAL SPECIFICATIONS
electrical box.
REMOTE LED
to TS1 (5&6).
HORN VOLUME -
Jumper 10 is used
to set the volume of
the sounder.
ON = 103db
OFF = 96db
AMPS
N/O
N/C
250mA
N/A
15mA
Jumper Select
✔
✔
1 Amp@
✔
✔
30 VDC
Page 5 of 6
Advertisement
