Advertisement
TIMERS
• Silent Time - "Open Door" Time - 0-2.5 min. in standard mode,
3 - 90 min. in Extended mode (selected by Jumper 9).
• Alarm Delay - "Warning" Time - 0-5 min. and "Infinite." Local
Beeping Warning Audible sounds during this time.
• Auto Reset - "Alarm" Time - 0-5 min. and Manual Reset.
Constant Alarm Audible sounds during this time.
• Shunt Delay - Valid Access Time prior to reset if Door is
unopened. 0, 5, 10, or 20 seconds (set with Jumpers 7 & 8).
TIMER SETTING TABLE
SIDE VIEW
SILENT TIME
SELECT
(Extended Silent Time Jumper)
SET
NORMAL
Jumper OFF
0 Sec
0
3 Sec
1
2
5 Sec
7 Sec
3
10 Sec
4
12 Sec
5
15 Sec
6
20 Sec
7
25 Sec
8
9
30 Sec
35 Sec
A
B
45 Sec
1 Min
C
1.5 Min
D
2 Min
E
2.5 Min
F
ALARM
AUTO
DELAY
RESET
TIME
TIME
EXTENDED
SELECT
SELECT
Jumper ON
3 Min
0 Sec
0 Sec
3.5 Min
3 Sec
3 Sec
4 Min
5 Sec
5 Sec
4.5 Min
7 Sec
7 Sec
5 Min
10 Sec
10 Sec
6 Min
12 Sec
12 Sec
7 Min
15 Sec
15 Sec
8 Min
20 Sec
20 Sec
9 Min
30 Sec
30 Sec
10 Min
45 Sec
45 Sec
20 Min
1 Min
1 Min
30 Min
2 Min
2 Min
40 Min
3 Min
3 Min
50 Min
4 Min
4 Min
60 Min
5 Min
5 Min
90 Min
INFINITE
MANUAL
CX-DA400 Door Prop Alarm Installation Instructions
TAMPER CIRCUIT
(CX-DA401 only)
• TAMPER SWITCH - Switch is located on stand-off under spring steel
actuator. (Cut cable tie to Enable switch)
• DOOR SUPERVISION - Enable with Jumper 1. Requires resistors on
Door Switch. (Schematic on Step 1 Pg.3)
OPERATION
VALID ACCESS / PROPPED DOOR OPERATION
ARMED STATE - Red LED (Green if Intrusion Detect is Off)
VALID USER INPUT - Shunt or Voltage Sense Input
LED - Changes to Green
DOOR - Opened by user, Silent Timer begins
DOOR - Closed by user, Returns to Armed State, or
- SILENT TIME TIMER - expires, then
AUDIBLE WARNING - Beeps to alert user locally
LED - Flashes Green
DOOR - Closed by user, returns to Armed State, or*
- SHUNT RECYCLE - 2nd Valid User Input (*if enabled)
SILENT TIME RESET - Silent Timer begins again
DOOR HELD/PROPPED - Alarm Delay Times out
LED - Flashes Red
AUDIBLE - Constant tone, Auto Reset (AR) Timer begins
OUTPUT - Door Prop Alarm relay toggles
DOOR CLOSED - After Door Prop Alarm exists
AUDIBLE - On until Auto Reset (AR) Time expires
LED - Flashes Red for AR Time
OUTPUT - Relay held for duration of AR Time
INTRUSION OPERATION
ARMED STATE - Red LED
DOOR Opened by invalid entry
LED - Flashes Red
AUDIBLE - Constant tone, Auto Reset (AR) Timer begins
OUTPUT - Intrusion/Tamper Alarm relay toggles
- DOOR CLOSED
LED - Flashes for duration of AR Time
AUDIBLE - Continues for duration of AR Time
OUTPUT - Changed for duration of AR Time
- REARM - After AR time expires OR by Manual reset
LED - Red (Armed State)
TAMPER OPERATION
ARMED STATE - Red LED (Door Supervision Enabled)
- TAMPER (Door circuit open/shorted, or if unit is
removed from wall)
LED - Flashing Red
AUDIBLE - Constant tone
OUTPUT - Intrusion/Tamper Alarm relay toggles
- RESET - Door normal, and Tamper switch closed
LED - Red (Armed State)
- Alarm is not reset with key.
(CX-DA401 only)
Page 2 of 6
Advertisement
