C.ITOH C310 User Manual page 52

. (1) I
LQ
I Switch
The
LQ
switch is used to select the function select mode at the start or end of set-up mode.
1) Start of Set-up Mode
(LQ lamp blinks)
Turning on the printer power while pressing the
I
LQ
I
switch
activates the set-up mode, and the currently set menu statuses
of the five most frequently used functions are automatically
printed.
(LQ lamp blinks)
Turning on the printer ower while simultaneously pressing the
I
LQ
I
switch and ON LINE switch activates the set-up mode.
All of the currently set functions and menu statuses are printed.
NOTE: In either case, the function select mode is activated.
2) End of Set-up Mode
[Function Select Mode]
(LQ lamp blinks)
(All the lamps except the POWER lamp go out -
and light depending on the set-up.)
Set-up mode is deactivated by pressing the
I
LQ
I
switch while the
function select mode is active in the set-up mode. The normal printer
mode then operates according to the newly set function and menu
numbers.
NOTE: If the printer power is turned off without pressing the
I
LQ
I
switch to end the set-up mode,
the setting changes made so far are ignored and the printer returns to the settings that were
in effect before entering set-up mode.
3) Selection of Function Select Mode
[Menu Select Mode]
(ON LINE lamp blinks)
(ON LINE lamp goes out and
LQ
lamp blinks)
The change from the menu select mode to the function select mode
is done by pressing the
I
LQ
I
switch.
3-2