10. Secure the conduit from the bagery box to the rear of the toilet, as shown below, using
the self-adhesive fasteners. Op\onally, use a drill to make holes in the ribs of the seat and
feed the conduit through.
11. Carefully ensure the conduit is located in the slot in the side of the bagery box and the
wires to the contact springs pass through the small channel. Re-agach the bagery box to
the seat again.
12. Re-connect the 12V power supply and test the installa\on by pinching the springs
together to observe the LED turning on.
Compo Closet 12.2023
20