Optional Installation: Converting Led Light Power To 12V - Compo Closet CUDDY User Manual

OpGonal installaGon: ConverGng LED light power to 12V
The liquids-full indicator LED can be configured to operate at 12V supplied at the main power
input. 12V Power Kit required and can be purchased separately.
Tools you'll need:
Philips Screwdriver
Flat Screwdriver
10mm Drill
Addi\onal Materials (not included):
12V Power Kit:
o 12v circuit Float switch
o Contact screws. Power extension cable Conduit
o Cable \es
o Self-adhesive fasteners
An 8 inch (200mm) length of string
Op\onal Materials:
9mm or ⅜" Drill
Steps:
1. Disconnect the 12V power input from CUDDY - this can be checked by confirming the fan
is not running.
2. Remove the screws securing the bagery box to the seat.
3. Remove the bagery box cover and any bagery that may be inside. Replace the bagery
box cover.
4. Disconnect the LED and 9v power input from the circuit board.
5. Unscrew the spring contacts and place them somewhere safe.
6. You can now remove the 9v circuit board and replace it with the 12v circuit board.
7. Connect the ring terminals to the spring contacts on the drain tube.
8. Connect the LED and the free end of the 12V power cable to the POWER connec\on on
the circuit board.
9. Pass the power extension cable through the split in the conduit.
Compo Closet 12.2023 19