Advertisement
3. Attach the speakers to the
Wide Plasma Display.
Hook
• Clip the hooks on the top and bottom mounting
brackets into the corresponding holes at the rear
of the Wide Plasma Display simultaneously, and
than lower the speaker into place.
• Attach the other speaker in the same manner.
5. Connect the speaker cables.
Preparing the ends of the
speaker cables
• After preparing the ends of the speaker cables as shown, attach the red cable to the (+) terminal and the black
cable to the (-) terminal. Do not reverse these connections.
When these speakers are attached to the plasma display they will not lie flat but be angled slightly inwards.
This is normal and is done to project an accurate sound.
Notes on use
1. Take care that the volume output from the Wide Plasma
Display does not exceed the rated limits of the speakers,
as excess volume can cause damage to these
components.
2. Do not place the speakers in the following places:
• Places which are exposed to direct sunlight
• Near heaters or other heat sources
• Places with high humidity
3. This set is equipped with magnetic resistant speakers but
be careful not to place them near CRT Televisions as it
may cause color patches.
Hooking hole
Hooking hole
Rear of Wide Plasma Display
While twisting
4. Secure the speakers in
place.
• Adjust the position of the speakers so that there is
a uniform clearance between the Wide Plasma
Display and the speakers, then securely tighten
the bracket mounting screws.
• Secure the top and bottom mounting brackets by
tightening the bracket mounting screws.
• Attach the other speaker in the same manner.
1. Push down the lever.
2. Insert
the cable.
3. Return the lever to
its normal position.
4. If they are extremely soiled, wipe them with a soft cloth that
has been soaked in a small amount of household
detergent, and then dry with a dry cloth.
• Do not use solvents such as alcohol or thinner.
• If using chemically-treated cloths, follow the instructions
on the cloth packaging.
5. Remove the dust on the speaker net using a duster or a
vacuum cleaner at low power. The net is simply cloth, so to
avoid damaging it be careful not to push excessively.
Bracket mounting
screw
Rear of Wide Plasma Display
1. Push down the lever.
3. Return the lever to its
normal position.
2. Insert
the cable.
3
Advertisement
