Download Print this page

Meter Description; Operation - Extech Instruments 401025 User Manual

Digital light meter

Advertisement

Meter Description

查询"401025"供应商
1.
LCD Display
2.
Data Hold Switch
3.
Power Off/Range Switch
4.
Analog Output Terminal
5.
Battery Compartment (rear)
6.
LUX/Fc Switch & Response Switch
7.
Light Sensor
8.
Zero adjust

Operation

1.
Select Units (Lux or Ft-candle) and Response Time (Fast or Slow) on the slide
switch. Typical selection is Slow and Fc using the gray lettering.
2.
Select the maximum range on the "Range Switch"
3.
Hold the "Light Sensor" so that the sensor faces the light source to be measured.
4.
The Display will indicate measured values. Use a range display multiplier if on the
Lux 20,000 and 50,000 ranges or on the Fc 5000 range.
5.
To "hold" a measurement, slide the "Data Hold Switch" to the "hold" position. The
reading will "freeze" in the display until the "Data Hold Switch" is released.
Note 1: An Over Range indication is a display of "I
range.
Note 2: For measurements made on the Fc 5000 range, the displayed reading must be
multiplied by 10.
Note 3: For measurements made on the Lux 20000 or 50000 range, the displayed
reading must be multiplied by 10 and 100 respectively.
Note 4: The meter will indicate values above the maximum ranges. The accuracy of
these measurements is unknown.
Range Display Multipliers
Range
Units
Multiplier
200
Fc
Direct reading
2000
Fc & Lux
Direct reading
5000
Fc
Reading x10
20,000
Lux
Reading x10
50,000
Lux
Reading x100
Example: If a measurement on the 5000 Fc range displays 350, then the actual
measured value is; 350 X 10 = 3500 Fc.
8
5
". If this occurs, switch to a higher
Lux
3
401025
1
2
3
6
4
7
Ver. 2.1
07/05

Advertisement

loading