Toro Z Master Professional 6000 Series Operator's Manual page 58

1
Figure 88
1. Deck-lift pedal
2. Height-of-cut pin
6. Insert the height adjustment pin into the 7.6 cm (3
inches) cutting height location.
7. Release the transport lock and allow the deck to lower
to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the level
surface to the front tip of the blade (Postion A) as
shown in Figure 89.
Note: The measurement should read 7.6 mm (3
inches)
3
G017027
3. Transport lock
2
1. 7.6 cm (3 inches) at
position A is correct
2. 8.3 cm (3-1/4 inches) at
position B is correct
10. For mower decks shown in Figure 90, fine-tune the
adjustment nut on the front deck lift assembly by
turning it.
Note: To increase the height, turn the adjustment nut
clockwise; to decrease, turn it counterclockwise.
2
1
G012430
1. Adjustment nut
2. Jam nut
11. For mower decks shown in Figure 91, fine-tune the
adjustment nut on the front deck lift assembly by
turning it (Figure 91).
58
Figure 89
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
3 4
2 1
Figure 90
3. Rear deck adjustment
4. Front deck adjustment