Connection To Amplifier; Removing Front Cover; Specifications - Yamaha NS-10MM User Manual

CONNECTION TO YOUR AMPLIFIER
BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE
AMPLIFIER IS SWITCHED OFF.
CONNECTIONS
● Connect the push-type input terminals at the rear of the
speakers to the speaker output terminals of your amplifier with
the provided speaker cables.
● One side of the speaker cable is marked by a blue line.
Connect the (+) terminals on both the amplifier and the
speakers using this blue-marked side. Connect the (–)
terminals on both components using the unmarked side of the
cable.
● Connect one speaker to the left (marked L) terminals of your
amplifier, and another speaker to the right (marked R)
terminals, making sure not to reverse the polarity (+, –). If one
speaker is connected with reversed polarity, the sound will be
unnatural and lack bass.
Procedures:
Press the tab on the terminal down, as shown in the figure.
Insert the bare speaker wire end properly into the terminal
hole. [Remove approx. 5 mm (1/4") insulation from the
speaker cable.]
Remove your finger from the tab to allow it to lock snugly on
the cable's wire end.
Test the security of the connection by tugging lightly on the
cable at the terminal.
Speaker (R)
Blue line
Speaker output
of the amplifier
Note
Do not let the bare speaker wires touch each other as this
could damage the speaker and/or the amplifier.
Blue line
Speaker (L)
Blue line
terminals
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at four points, and
can be removed if desired. To remove the cover, hold on to both
sides and slowly pull straight away from the speaker. To
reattach, line up the four holes on the inside surface of the cover
with the four corresponding pegs on the speaker and push
gently.
Note
When the cover is removed, take care not to touch the
speaker units with your hands or to exert excessive force
with tools.
You can also use the screw holes on the bottom of the speaker
for installing the speakers (if you not use the provided
mounting brackets).
A screw with a diameter of 4 mm and a pitch
of 0.7 mm can be used.
60 mm
(Depth of hole : 8mm)

SPECIFICATIONS

Type .........................2-way acoustic-suspension speaker system
Speaker Unit .....................................................9 cm cone woofer
Input Terminal ...............................................................Push-type
Nominal Impedance ...........................................................6 ohms
Frequency Response ..........................................100 Hz – 20 kHz
Nominal Input Power ..............................................................40W
Maximum Input Power .........................................................100W
Sensitivity .....................................................................88 dB/w/m
Crossover Frequency ...........................................................5 kHz
Dimensions (WxHxD)....................................107 x 191 x 140 mm
Weight .............................................................1.5 kg (3 lbs. 5 oz.)
Accessories ............................................Speaker cable (10m) x 2
* Specifications subject to change without notice due to product
improvements.
* Care should be taken not to exceed the input power values
noted above.
2.5 cm tweeter
(4-3/8" x 7-1/2" x 5-1/2")
Mounting bracket x 2
Screw x 4
Pad x 4
VU 94700