Table of contents Table of contents General information..........................6 1.1 Symbols and signal words....................... 6 Safety instructions............................ 9 Features................................ 13 Installation..............................14 Starting up..............................20 Connections and controls........................22 Operation..............................27 7.1 Starting the device.......................... 27 7.2 Main menu............................27 7.3 ...
Page 4
Table of contents Plug and connection assignments....................45 Cleaning............................... 46 Protecting the environment....................... 47 Stage Quad LED Bundle RGB WW LED Lighting Set...
Page 5
Stage Quad LED Bundle RGB WW LED Lighting Set...
Our products and documentation are subject to a process of continuous development. They are therefore subject to change. Please refer to the latest version of the documentation, which is ready for download under www.thomann.de. 1.1 Symbols and signal words In this section you will find an overview of the meaning of symbols and signal words that are used in this document.
Page 7
General information Signal word Meaning DANGER! This combination of symbol and signal word indicates an immediate dangerous situation that will result in death or serious injury if it is not avoided. WARNING! This combination of symbol and signal word indicates a pos‐ sible dangerous situation that can result in death or serious injury if it is not avoided.
Page 8
General information Warning signs Type of danger Warning – danger zone. Stage Quad LED Bundle RGB WW LED Lighting Set...
Safety instructions 2 Safety instructions Intended use This device is intended for use as an electronic lighting effect by means of LED technology. The device is designed for professional use only and is not suitable for use in households. Use the device only as described in this user manual.
Page 10
Safety instructions DANGER! Danger to life due to electric current! Within the device there are areas where high voltages may be present. Never remove any covers. There are no user-serviceable parts inside. Do not use the device when covers, safety equipment or optical components are missing or damaged. DANGER! Danger to life due to electric current! A short circuit could lead to a fire hazard and risk of death.
Page 11
Safety instructions NOTICE! Damage to the device if operated in unsuitable ambient conditions! The device can be damaged if it is operated in unsuitable ambient conditions. Only operate the device indoors within the ambient conditions specified in the “Technical specifications” chapter of this user manual. Avoid operating it in environments with direct sunlight, heavy dirt and strong vibrations.
Page 12
Safety instructions NOTICE! Risk of fire due to installation of a wrong fuse! Using fuses of a different type than compatible with the device may cause a fire and seriously damage the device. Only use fuses of the same type. Observe the labelling on the device casing and the information in the "Technical data” chapter. NOTICE! Risk of short circuit due to changing the connection wiring during operation! If connection cables of individual spots are removed or replaced during operation, short circuits may occur that can irreparably...
Features 3 Features The LED lighting set offers an ideal combination of white and coloured light for parallel illumination of stage and dance floor in various shades. Four LED spots with each seven 4-in-1 LEDs, 4 W each, pre-mounted on T-bar: Red, green, blue, warm white Control via DMX (six different modes), via buttons and display on the device, foot switch (item no.
Installation 4 Installation Unpack and check carefully there is no transportation damage before using the unit. Keep the equipment packaging. To fully protect the product against vibration, dust and moisture during transportation or storage use the original packaging or your own packaging material suitable for transport or storage, respectively.
Page 15
Installation NOTICE! Damage to the device by disconnecting LED spots during operation! If individual LED spots are disconnected from the device during operation, the device can get damaged. Operate the device only when all LED spots are connected. Always disconnect the device from the mains before removing the LED spots. NOTICE! Risk of overheating and fire due to inadequate distance and bad ventilation! If the distance between the light source and the illuminated surface is too short or...
Page 16
Installation NOTICE! Potential property damage due to unsuitable stands! If the device is mounted on an unsuitable stand, there is a risk that the stand will fall over and cause damage. Only use stands whose maximum bearing capacity is at least as high as the weight of the device.
Page 17
Installation Pre-mounted spots The four spots are pre-mounted on the T-bar. Locking screws to fix the height and inclination angle. Threads for attaching additional effects units or for hanging using the C-hooks. Electrical connection of the spot at the T-bar (pre-mounted). Locking screw for fixing the spots on the T-bar and the horizontal orientation (dispersion direction).
Page 18
Installation Inserting the battery into the Push the lock of the battery holder towards the centre of the housing and pull out the battery remote control holder like a drawer. Insert the batteries. The battery is correct if the positive pole points to the housing base of the remote control.
Page 19
Installation Please note that this device must not be connected to a dimmer. Stage Quad LED Bundle RGB WW LED Lighting Set...
Starting up 5 Starting up Create all connections while the device is off. Use the shortest possible high-quality cables for all connections. Take care when running the cables to prevent tripping hazards. Connections in DMX mode Connect the DMX input of the device to the DMX output of a DMX controller or another DMX device.
Page 21
Starting up Connections in master/slave When you configure a group of devices in master/slave mode, the first unit will control the mode other units for an automatic, sound-activated, synchronized show. This function is ideal when you want to start a show immediately. Connect the DMX output of the master device to the DMX input of the first slave device.
Connections and controls 6 Connections and controls Stage Quad LED Bundle RGB WW LED Lighting Set...
Page 23
Connections and controls 1 [Power In] | Rubber panel plug for the power supply with fuse holder. 2 Display and function buttons [Mode] | Activates the main menu and toggles between menu items. Closes an open submenu. [Setup] | Selects an option of the respective operating mode, confirms the set value. [Up] | Increases the displayed value by one.
Page 24
Connections and controls Infrared remote control (item no. 354223, Since the universal remote control can be used for several device types, some buttons optionally available) may not be assigned and therefore have no function. & ö Stage Quad LED Bundle RGB WW LED Lighting Set...
Page 25
Connections and controls 1 [ON/OFF] | Turns the device on and off. 2 [AUTO] | Activates “Automatic” mode. 3 [PRG] | Activates the “Pre-programmed automatic show” mode. Select the required programme with [+] and [–]. 4 [SOUND] | Activates “Sound control” mode. Set the sensitivity of the built-in microphone with [+] and [–]. 5 [SPEED] | Activates the setting mode for the programme speed.
Page 26
Connections and controls Foot switch unit (item no. 279058, optionally available) ö 1 [Auto Run/Program] | Activates “Automatic” mode (playback of pre-programmed automatic shows). 2 [Sound Active] | Activates “Sound control” mode (playback of sound-controlled automatic shows). 3 [Freeze] | Pauses the running show (“freeze”) and resumes it after a break. 4 [Blackout] | Blacks out all LEDs or turns them back on again.
Operation 7 Operation 7.1 Starting the device Connect the device to the mains to start operation. After a few seconds, the display indicates that a reset is in progress. The device is now operational. 7.2 Main menu Press [Mode] to activate the main menu and select an operating mode. Use [Setup] to select further options.
Page 28
Operation “Pre-programmed automatic A pre-programmed automatic show can only be activated if the device is operating in stand- show” operating mode alone mode or as master in a master/slave combination. This setting is only relevant if the device is not controlled via DMX. Press [Mode] repeatedly until the display shows ‘Pr.xx’...
Page 29
Operation DMX mode This setting is only relevant when the device is controlled via DMX. Press [Mode] repeatedly until the display shows ‘d.xxx’ . Press [Setup]. Now you can set the number of the first DMX channel to be used by the device (DMX address). Use [Up] and [Down] to select a value between 1 and 512 (display shows ‘d.001’...
Page 30
Operation ‘10ch’ (ten channels) ‘18ch’ (eighteen channels) Sound control A sound-controlled show can only be activated when the unit is operating in stand alone mode or as master in a master / slave combination. This setting is only relevant if the device is not controlled via DMX.
Page 31
Operation Constant monochrome pattern A constant monochrome pattern can only be activated when the unit is operating in stand alone mode or as master in a master / slave combination. This setting is only relevant if the device is not controlled via DMX. Press [Mode] repeatedly until the display shows ‘Colr’...
Operation 7.4 Functions in 2-channel DMX mode Channel Value Function 0…10 Pre-programmed automatic show Pr.01 11…21 Pre-programmed automatic show Pr.02 231…241 Pre-programmed automatic show no. 22 242…255 Sound-controlled show Function depending on setting of channel 1 Channel 1 = 0…10 0…16 17…33 Basic colour cyan...
Page 35
Operation Channel Value Function 119…135 Basic colour light green 136…152 Basic colour light blue 153…169 Basic colour yellow 168…186 Basic colour warm white 187…203 Basic colour red 204…220 Basic colour green 221…237 Basic colour blue 238…254 Basic colour amber maximum brightness Channel 1 = 11…241 0…255...
Operation 7.5 Functions in 4-channel DMX mode Channel Value Function 0…255 Red intensity (0% to 100%) for all LEDs 0…255 Green intensity (0% to 100%) for all LEDs 0…255 Blue intensity (0% to 100%) for all LEDs 0…255 White intensity (0% to 100%) for all LEDs 7.6 ...
Operation 7.7 Functions in 8-channel DMX mode Channel Value Function 0…255 Dimmer (0% to 100%) 0…255 Red intensity (0% to 100%) for all LEDs 0…255 Green intensity (0% to 100%) for all LEDs 0…255 Blue intensity (0% to 100%) for all LEDs 0…255 White intensity (0% to 100%) for all LEDs No function...
Page 38
Operation Channel Value Function 17…33 Basic colour cyan 34…50 Basic colour pink 51…67 Basic colour magenta 68…84 Basic colour orange 85…101 Basic colour cold white 102…118 Basic colour pompadour 119…135 Basic colour light green 136…152 Basic colour light blue 153…169 Basic colour yellow 170…186...
Page 39
Operation Channel Value Function 0…255 Programme speed Pr.02…Pr.22 Channel 6 = 242…255 0…255 Sound-controlled operation SO.01…SO.15 0…255 Strobe effect (0% to 100%) Stage Quad LED Bundle RGB WW LED Lighting Set...
Operation 7.8 Functions in 10-channel DMX mode Channel Value Function 0…255 Dimmer (0% to 100%) 0…255 Red intensity (0% to 100%) for all LEDs of spots 1 and 2 0…255 Green intensity (0% to 100%) for all LEDs of spots 1 and 2 0…255 Blue intensity (0% to 100%) for all LEDs of spots 1 and 2 0…255...
Operation 7.9 Functions in 18-channel DMX mode Channel Value Function 0…255 Dimmer (0% to 100%) 0…255 Red intensity (0% to 100%) for all LEDs of spot 1 0…255 Green intensity (0% to 100%) for all LEDs of spot 1 0…255 Blue intensity (0% to 100%) for all LEDs of spot 1 0…255...
Operation Channel Value Function 0…255 Green intensity (0% to 100%) for all LEDs of spot 4 0…255 Blue intensity (0% to 100%) for all LEDs of spot 4 0…255 White intensity (0% to 100%) for all LEDs of spot 4 0…255 Strobe effect (0% to 100%) 7.10 ...
Technical specifications 8 Technical specifications Light source 28 × RGBWW LED, 4 W each Optical properties Beam angle 40° Control IR remote control (optional) Foot switch unit (optional) Number of DMX channels 2, 4, 5, 8, 10, 18 Input connections Power supply C14 rubber panel plug DMX control...
Page 44
Technical specifications International Protection Rating IP20 Mounting options Stand M8 thread on the top Dimensions (W × H × D) 1,200 mm × 330 mm × 70 mm Weight 12.5 kg Ambient conditions Temperature range 0 °C…40 °C Relative humidity 20%…80% (non-condensing) Further information Spotlight included Effect devices included No LED bars included Controller included...
Page 45
Plug and connection assignments 9 Plug and connection assignments Introduction This chapter will help you select the right cables and plugs to connect your valuable equip‐ ment so that a perfect light experience is guaranteed. Please take our tips, because especially in ‘Sound & Light’ caution is indicated: Even if a plug fits into a socket, the result of an incorrect connection may be a destroyed DMX controller, a short circuit or ‘just’...
Page 46
Cleaning 10 Cleaning Optical lenses Clean the optical lenses, that are accessible from the outside, regularly in order to optimize the light output. The frequency of cleaning depends on the operating environment: wet, smoky or particularly dirty surroundings can cause more accumulation of dirt on the optics of the device.
Page 47
Protecting the environment 11 Protecting the environment Disposal of the packing material Environmentally friendly materials have been chosen for the packaging. These materials can be sent for normal recycling. Ensure that plastic bags, packaging, etc. are disposed of in the proper manner.
Page 48
Repairing a device or passing it on to another user is an ecologically valuable alternative to disposal. You can return your old device to Thomann GmbH at no charge. Check the current conditions on www.thomann.de. If your old device contains personal data, delete those data before disposing of it.
Page 49
Notes Stage Quad LED Bundle RGB WW LED Lighting Set...
Page 50
Notes Stage Quad LED Bundle RGB WW LED Lighting Set...
Need help?
Do you have a question about the STAIRVILLE Stage Quad LED Bundle RGB WW and is the answer not in the manual?
Questions and answers