Product Clearances - Monogram ZDWI240 Installation Instructions Manual

PRODUCT CLEARANCES

The door swing opening angles from the factory are set at 95° for models ZDWI240 and ZDBI240 and 110° for
models ZDWR240 and ZDBR240 with no adjustment or stop at 90°.
Choose the location:
• These products may be closed in on the top and three sides as long as the front is unobstructed for air circulation
and proper access to the door.
• Do not install these products where the temperature will go below 55°F (13°C) or above 100°F (37°C).
• These products are not designed to be stacked one over the other.
• Right hand models illustrated. Allow the same clearances on the opposite side for left hand models.
• Test the door swing. Carefully open and close the door. The door should not rub or catch on adjacent cabinetry.
installation.
When installing in a corner or near a wall, note the recommended clearance distances in the following chart:
Door Opening
Factory Setting Door Stop Angle
Angle
Minimum door swing clearance at
W
Minimum door swing clearance at
X
90° (allowing racks to slide out)
NOTE: Clearances are based on the recommended maximum 2 9/16" (65mm) handle height.
W Minimum to Wall
95° Door
Swing
95°
8
Design Guide
Descriptions
6" (152 mm)
door stop
4 1/2" (114 mm)
W Minimum to Wall
110° Door
Swing
110°
Models
ZDWI240 ZDWR240
95° 110°
11" (279 mm)
4" (102 mm)
ZDBI240 ZDBR240
95° 110°
6" (152 mm) 11" (279 mm)
4 1/2" (114 mm) 4" (102 mm)
90 Door
B
Swing
R
F
90
Minimum to Wall
X
31-1000646-2