The Installation Space; Product Clearances; Side-By-Side Installation - Monogram ZDWI240 Installation Instructions Manual

THE INSTALLATION SPACE (cont.)
CABINET
Front edge of product case
Front face
cabinets when installed with a Dim. A-width
be recessed or set back behind the door and
even with the front edge of the product case.
Product
ZDWI240, ZDBI240
ZDWC240, ZDWR240
ZDBC240, ZDBR240

PRODUCT CLEARANCES

The stainless steel wine chiller, wine reserve and beverage
center is factory set for a 110° door swing. Models that
accept custom panels have a 95° door swing.
When installed in a corner:
• Allow 4" min. clearance on the hinge side for the 90° door
swing and to allow racks to slide out.
• Allow 10" minimum clearance on the hinge side for a full
110° door swing. (Models ZDWI240WII and ZDBI240WII
have a 95° door swing.)
NOTE: Custom handle clearances may vary, depending on
custom handle depth.
10" Minimum
to Wall
110*
*95 Door Swing on Custom Frame Models
• The door swing is reversible on all models. If desired,
change the door swing before installation or before
installing the custom frame panel.
Choose the location:
• These products may be closed in on the top and three sides
as long as the front is unobstructed for air circulation and
proper access to the door.
• Do not install these products where the temperature will go
below 55°F (13°C) or above 90°F (32°C).
• Do not install where it will be subject to direct sunlight, heat
or moisture.
Design Guide
Flush
Installation
Dim. A
Filler panel or cleat
to be set back even
with front of case.
CABINET
110°
120°
Dim. A
1"
1/2"
1/2"
90° Door Swing
21-5/8"
23-5/8"
90
4" Minimum
to Wall
CABINET
Front edge of product case
Dim. A
In a standard installation, the product
will project forward of adjacent
cabinets. See Dim. A.
Product
ZDWI240, ZDBI240
ZDWC240, ZDWR240
ZDBC240, ZDBR240
PRODUCT CLEARANCES (Cont.)
• These products are not designed to be stacked one over
the other.
Black or Stainless Steel Toekick Options
• These products are shipped with a black toekick
installed. An optional stainless steel toekick is also
supplied with each product. For shipping purposes, the
stainless steel toekick is secured to the back of the unit.
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacity by installing two Monogram
beverage centers, wine chillers or wine reserves together.
Or, for a complete refreshment center, install any two
of these units together.
• A side-by-side installation requires at least a 47-1/2"-
wide minimum opening for standard installation and
of stainless steel models. A 49-1/2"-wide minimum
of custom framed models.
• Products must operate from separate, properly
grounded receptacles.
5
Standard
Installation
CABINET
Front face
110°
120°
Dim. A
2"
1-3/4"
1-3/4"