CONTENTS
Important Information .................................................2
Parts Required...............................................................4
Staining Wood Panel Fronts .........................................4
Product Location............................................................4
The Installation Space Standard Installation .................7
The Installation Space Flush Inset Installation ..............7
Step 1, Remove Packaging and Installation Parts ........9
Step 2, Reversing the Door ...........................................9
Step 3, Install Custom 3/4" Door Panel and Handle ......12
Step 4, Level................................................................13
Step 7, Slide Product into Cutout ................................14
ZDWI240 AND ZDBI240 MODELS ONLY
PARTS REQUIRED
• Custom handle
• Assembled overlay panel
• Screws
For all MODELS ZDWI240, ZDWR240,
ZDBI240, ZDBR240
PARTS SUPPLIED
Black or Stainless Steel Toekick
• These products are shipped with a stainless steel toe-
kick and a black toekick. For shipping purposes, one of
the toe kicks will be secured to the back of the unit, and
the second will be installed on the unit. Keep the unused
toekick and any unused parts for future use.
TOOLS/HARDWARE REQUIRED
• Adjustable wrench
• Carpenter's glue (ZDWI240 and ZDBI240 models only)
• Screwdriver
4
Design Guide
PARTS SUPPLIED
• Handle side trim
WARNING
CUT HAZARD
Cabinet edges along stamp/cut-out areas may be sharp.
Avoid placing hands, fingers, or other appendages near
these areas. Failure to do so can result in cuts.
AVERTISSEMENT
Les bords de la caisse et les zones comportant un code
d'identication ou des découpes peuvent être tranchants.
Garder les mains, les doigts ou autres appendices éloignés
de ces zones. Le non-respect de cette instruction peut causer
des coupures.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (12.7°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Do not install the refrigerator in a location exposed to water
(rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully loaded.
STAINING WOOD DRAWER
FRONTS
use, oil from hands may accumulate and stain the wood.
• The drawer fronts may be stained and sealed to match
adjacent cabinetry. The tinted glass will make the
stained wood appear darker. A true color match can be
seen only when the door is opened.
• Apply the stain and sealer according to the manufac-
turer's instructions. To avoid unpleasant odor, keep the
door open to ventilate and allow the stain/sealer to dry
completely before using the product.
Risque de coupure
31-1000646-2