Get Started; Install The Car Audio - Philips CID2780 User Manual

w PHOTO/ZOOM
‡ Zoom in or out a picture/video image.
x F/R
‡ Switch to front/rear control mode.
y Navigation buttons
/
‡ Skip to the previous/next preset
station.
‡ Skip to the previous/next folder.
‡ Search backward/forward for DVD
video.
‡ Move cursor up/down.
/
‡ Skip to the previous/next track.
‡ Move cursor to left/right.
‡ Press the navigation button down
‡ Start play or pause.
‡ &RQÀUP VHOHFWLRQ
{
‡ Return to previous menu or exit.
| SOURCE
‡ Select source.

3 Get started

Caution
‡
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.

Install the car audio

These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any questions regarding installation kits, consult
your Philips car audio dealer.
Caution
‡
This unit is designed for negative ground (earth) 12 V
DC operation only.
‡
Always install this unit in the car dashboard. Other
locations can be dangerous as the rear of the unit heats
up during use.
‡
To avoid short-circuit: before you connect, ensure that
the ignition is off.
‡
Ensure that you connect the yellow and red power
supply leads after all other leads are connected.
‡
Ensure that all loose leads are insulated with electrical
tape.
‡
Ensure that the leads do not get caught under screws
or in moving parts (e.g. seat rail).
‡
Ensure that all ground (earth) leads are connected to a
common ground (earth) point.
‡
Use only the supplied mounting hardware for a safe
and secure installation.
‡
,PSURSHU IXVHV FDQ FDXVH GDPDJH RU ÀUH :KHQ \RX
need to change the fuse, consult a professional.
Connect wires
Check the car's wiring carefully, then make the
connections as illustrated.
EN 9