Kenwood TK-3101 Instruction Manual page 14

1 Plug the AC adaptor
cable into the adaptor
jack located on the rear
of the charger.
2 Plug the AC adaptor into
an AC outlet.
3 Slide the NiCd battery
pack or the transceiver
equipped with a NiCd
battery pack into the
charging slot.
e Make sure the metal
contacts on the battery
pack come in contact
with the charging
terminals.
e The charger LED lights
and charging begins.
4 After charging the
supplied KNB-14 battery
pack for 8 hours, remove
it or the transceiver from
the charger.
e The charger does not
turn OFF automatically
after charging is
completed.
5 Unplug the AC adaptor
from the AC outlet.
Note: It takes approximately 15 hours to fully charge the optional
KNB-15A battery pack.
wna DO on eR
No power.
Battery power dies
shortly after charging.
Cannot talk to or hear
other members in your
group.
Other voices (besides
group members) are
present on the
channel.
The battery pack may be
dead. Recharge or replace
the battery pack.
The battery pack may not be
installed correctly. Remove
the battery pack and install it
again.
The battery pack life is
finished. Replace the
battery pack with a new one.
Make sure you are using the
same frequency and QT/
DQT tone as the other
members in your group.
Other group members may
be too far away. Make sure |
you are within range of the
other transceivers.
Change the QT/DQT tone.
Be sure to change the tone
on all transceivers in your
group.
21 & Bree