Table of Contents
Advertisement
Assembly Instructions
Hydraulic Compressor Assembly (if ordered)
Prepping – The crate labeled 2940-055 should include the Yetter hydraulic compressor, 1 liter bottle of oil, 2940-181 hyd. comp.
solenoid/pressure switch harness, & 2940-189 10' hyd. communication harness. The 2940-181 & 2940-189 can be discarded.
Remove compressor from crate. Remove housing by removing 6 bolts (4 are pictured in picture 1 below, the other 2 are on
opposite side of the housing) using a ratchet with 7/16 socket & a 7/16 wrench. Remove the dipstick & slowly fill pump with
provided oil until oil reaches the fill line on the sight glass. Fill pump slowly as there is a significant delay between oil entering
pump & seeing oil on the sight glass. Confirm the oil level is full on the dipstick as well. Reinstall the dipstick, housing, & control
block. Remove the wing nut on the air filter housing, remove the air filter cover, & inspect the condition of the air filter. Reinstall the
filter, cover, & wing nut making sure the filter is sealed between the filter base plate & cover.
Mounting – Each strip till machine will have its own unique mounting location. Select an area to mount the compressor that is
centrally located near hitch of tractor. YOU SHOULD EXERCISE YOUR OWN BEST JUDGEMENT TO FIT YOUR SITUATION.
Use mounts supplied or depending on application different mounts may need to be built or Yetter mounts may need modified. Be
sure to check clearance in all locations, especially noting tractor tires, folding/unfolding toolbar for transport mode, marker arms, &
fertilizer tanks. The 2940-086 universal mount kit is most commonly used mount for this application, longer bolts may be needed.
8
Advertisement
Table of Contents
