Table of Contents
Advertisement
Electric Compressor Assembly (if ordered)
Mounting – Each strip till machine will have its own unique mounting location. Select an area to mount the compressor that is
centrally located near hitch of tractor. YOU SHOULD EXERCISE YOUR OWN BEST JUDGEMENT TO FIT YOUR SITUATION.
Use mounts supplied or depending on application different mounts may need to be built or Yetter mounts may need modified. Be
sure to check clearance in all locations, especially noting tractor tires, folding/unfolding toolbar for transport mode, marker arms, &
fertilizer tanks. The 2940-086 universal mount kit will be most commonly used mount for this application.
Power Cable Installation - : Install the 2940-150 main power cable with 80A breaker on the operating tractor's battery. Red
cable installs on the positive (+) battery terminal post and the black cable installs on the negative (-) battery terminal post. From
the open 2 pole Anderson connector of the 2940-150, safely route & install the appropriate length of main power extension
cables, 2940-151 is a 10ft main power extension & 2940-163 is a 20ft main power extension, into the Anderson connector that
comes out of the bottom of the compressor housing. If operating tractor is articulating or if compressor is further back on the
planter than the hitch, more extension cables may be needed. Cable length from the battery to the compressor should not
exceed 50 feet. Longer than 50 feet distances cause the 80A breaker to become weak and trip often. If distance is
greater than 50 feet, heavier cable needs made using 00 gauge wire.
10
Assembly Instructions
Advertisement
Table of Contents
