Table of Contents
Advertisement
Features:
Parallel Linkage/Pneumatic Row Unit Down Force for consistency for all field contours, soil types, & conditions.
Designed for use with pneumatic row cleaner to enhance strip cleanliness
Operating speeds between 6-10mph & depth adjustment between 1"-4"
Two Shark Tooth or Shallow (13) wave wheels run at an angle to churn dirt for optimal seed bed preparation
Optional liquid or dry fertilizer kits are available for additional value to this field pass
Heavy Duty, Pneumatic Rolling Basket conditions the strip
Mounting bolts and hardware
All hardware is Grade 5 unless otherwise noted. Grade 5 cap screws are marked with 3 radial
lines on the head. If hardware must be replaced, be sure to replace it with hardware of equal
size, strength & thread type. Refer to the torque values chart when tightening hardware.
Important: Over-tightening hardware can cause just as much damage as under-tightening.
Tightening hardware beyond the recommended range can reduce its shock load capacity.
The chart below is a guide for proper torque. Use it unless a specified torque is called
out elsewhere in the manual. Torque is the force applied to the end of the handle or
cheater bar, times the length of the handle or bar.
The following table shows torque in ft.-lbs. for coarse thread hardware.
CHECK HARDWARE DAILY FOR DAMAGE, WEAR, & LOOSENESS. TIGHTEN AS NEEDED
TOOLS NEEDED: ½" Drive Impact, ½" Drive Torque Wrench, ¼" Drive Socket &
Ratchet Set, Funnel for adding oil in Yetter Hyd. Compressor, Air Tubing Cutters,
Side Cutters, Pliers, Standard Wrenches, Standard Sockets, Tape Measure, Marker
2984-050-R Yetter Strip Freshener
BOLT TORQUE
Use a torque wrench wherever possible.
5
Advertisement
Table of Contents
