Table of Contents
Advertisement
Assembly Instructions
Row Cleaner Assembly
Assemble wide/narrow pivot arms, depending on application, to mount on strip freshener CC unit. Narrow arms go on inside of row cleaner
mount plates & wide arms go on outside of row cleaner mount plate. Place a pivot bushing in rear hole on each side of pivot arms, align hole on
each arm with rear hole on each side of row cleaner mount bracket, slide a 5/8" X 2" bolt through, & fasten with a 5/8" lock nut. Install down stop
& up stop components next. Install a ½" X 1 ¾" bolt through remaining 2 holes on each side of row cleaner mount plate, slide a 9/16" spacer over
each bolt, & fasten in place with a ½" lock nut. Assemble air cylinder to row cleaner; place clevis on rod end of cylinder over hole on pivot arm
handle & install shorter pin & 1/8" cotter pin. Install anchor end of cylinder between mount tabs on row cleaner faceplate & install longer pin &
1/8" cotter pin. If using beveled wheel row cleaner assemblies, place half-moon bearing shield over D-bolt, slide D-bolt in D-hole on pivot arms, &
fasten wheel assembly to pivot arm using a 5/8" lock washer & 5/8" nut. Shark tooth wheel row cleaner assemblies do not need half-moon
bearing shield, just slide D-bolt thru pivot arm & fasten using 5/8" lock washer & 5/8" hex nut. Install row cleaner wheels in back set of holes on
pivot arm or you can stagger them if desired: Left wheel leads, right wheel trails on left hand side of toolbar, right wheel leads, left wheel trails on
right hand side of toolbar. REMOVE PLASTIC GUARDS FROM WHEEL ASSEMBLIES AFTER INSTALLATION IS COMPLETE!!!
7
Advertisement
Table of Contents
