Advertisement
6 Alignments and Adjustments
6-2-1 General Control
Use general control to test and adjust the shape
and size of the display.
1. Simultaneously press buttons 29 and 23 to
toggle between General Control and Color
Control. Select "General Control."
Standard Save: Press button 10 to do a
memory data dump and load the standard
picture data from the EPROM on the micom
control jig.
Note: This step is necessary only if the
EPROM on the control jig has more recent
data than the EPROM on the monitor PCB.
Check for a Service Bulletin or Service Manual
Supplement.
Optimize the standard timing mode (60 kHz
/75 Hz) using the micom control jig as
described on pages 6-4 and 6-5 of this manual.
After completing all standard timing mode
adjustments, press button 15 to save the data
for all modes. The monitor's microprocessor
adjusts the other modes according to a
predefined formula.
Using a signal generator, scan the other timing
modes and make adjustments as needed. Each
time you make a change, press button number
5 to save the data.
Samsung Electronics SyncMaster 17GLi
6-2-2 Color Control
Use color control to test and adjust the color
coordinates the monitor displays.
1. Simultaneously press buttons 29 and 23 to
toggle between General Control and Color
Control. Select "Color Control."
Press button 8 (for 9300K setting) or 9 (for
6500K settings) to do a memory data dump
and to load the standard picture color data
from the micom control jig.
Note: This step is necessary only if the
EPROM on the control jig has more recent
data than the EPROM on the monitor PCB.
Check for a Service Bulletin or Service Manual
Supplement.
Optimize the standard timing mode using the
micom control jig as described on pages 6-6
and 6-7 of this manual.
Press button 5 to save the picture color data.
Press button 10 to save ACL data.
When you are through, disconnect the micom
control jig and proceed with other tests and
adjustments.
6-3
Advertisement
