A substitute replacement that does not have the same safety characteristics as the recommended replacement part might create shock, fire and / or other hazards. Product safety is under review continuously and new instructions are issued whenever appropriate. SyncMaster 170T/180T...
Use only an anti-static solder removal device. Some brushing clothes together, or lifting your foot from solder removal devices not classified as “anti-static” a carpeted floor can generate enough static can generate electrical charges sufficient to damage electricity to damage an ESD. ESDs. SyncMaster 170T/180T...
Storage Temperature : -68°F to 113°F (-20°C to 45°C) Humidity : 5 % to 95 % • SyncMaster 170T/180T comply with SWEDAC (MPRII) recommendations for reduced electromagnetic fields. • Designs and specifications are subject to change without prior notice. SyncMaster 170T/180T...
Rx2- No Connection Rx2+ DDC Power Input (+5V) Self Raster No Connection Connection Signal Output (+5V) No Connection Rx0- DDC Clock (SCL) Rx0+ DDC Data (SDA) No Connection No Connection Rx1- No Connection Rx1+ RxC+ No Connection RxC- SyncMaster 170T/180T...
B : Horizontal sync width O : Frame time total P : Vertical sync width C : Back porch D : Active time Q : Back porch R : Active time E : Front porch S : Front porch SyncMaster 170T/180T...
3 Disassembly and Reassembly This section of the service manual describes the disassembly and reassembly procedures for the SyncMaster 170T/180T TFT-LCD monitors. WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these components. 3-1 Disassembly (SyncMaster 170T) Cautions:1. Disconnect the monitor from the power source before disassembly.
Page 10
Panel and the CN600 connector on the Main 13. Remove the 2 screws on the Function PCB PCB. from the Front Cover and remove the Function PCB and Function Knob. 3-3 Reassembly Reassembly procedures are in the reverse order of Disassembly procedures. SyncMaster 170T/180T...
Does proper DC 5 V appear at Check IC105 and related circuit. Pin 4 of IC105? Does proper 5 V - signal appear at Check IC602 and related circuit. Pin 42 of IC602 (SW_REG_EN)? (CN102, Function Key) Check Q102, Q103 and Q105. SyncMaster 170T/180T...
Page 12
A_MX_HSYNC) and does the digital video signal appear at the output port PDA, PDB)? During power on-off dose the input signal appear at the R 410 and R 411 ? Check IC501 and related circuit. (MX - SDA, MX - SCL) SyncMaster 170T/180T...
Page 13
Check IC101 and related circuit. digital video signal appear at the output port PDA, PDB)? During power on-off dose the input signal Check IC501 and related circuit. appear at the R 410 and R 411 ? (MX - SDA, MX - SCL) SyncMaster 170T/180T...
Page 15
11 12 13 10 of IC404? CH1 RMS = 4.18V While pushing a front control button does any pulse appear Check IC404 and related circuit. at Pin 12 of IC404? CH1 RMS = 3.26V Replace IC404. CH1 RMS = 3.26V SyncMaster 170T/180T...
Page 16
6 Exploded View and Parts List 6-1 SyncMaster 170T SyncMaster 170T/180T...