Table of Contents
Advertisement
[HDMI Audio]
Select an HDMI audio output when you connect
this product and the TV/audio device with an HDMI
cable.
•
[Bitstream] – Select the best original HD
audio experience (only via an HD audio
compatible receiver).
•
[Auto] – Detect and select the best supported
audio format automatically.
[Digital Audio]
Select an audio format for the sound output from
the DIGITAL OUT jack (coaxial/optical).
•
[Auto] - Detect and select the best supported
audio format automatically.
•
[PCM] - The audio device does not support
multi-channel format. Audio is downmixed to
two-channel sound.
•
[Bitstream] - Select the original audio to
experience Dolby or DTS audio (BD-video
special sound effect is disabled).
Note
•
Ensure that the audio format is supported by the disc
and the connected audio device (amplifier/receiver).
•
When
[Bitstream] is selected, interactive audio like
button sound is muted.
[PCM Downsampling]
Set the sampling rate for PCM audio output from
the DIGITAL OUT jack (coaxial/optical).
•
[On] – PCM audio is down-sampled at 48kHz.
•
[Off] – For BD or DVD recorded in LPCM
without copyright protection, two-channel
audio signals up to 96 kHz are output as LPCM
signals with no conversion.
[Speaker Setup]
Optimize the surround output for the connected
speaker system.
•
[Speaker Setup ] – Activate the test tone for
the speakers and the subwoofer.
•
[Speaker Distance] – Set the delay time for
the speakers and the subwoofer if they are
placed closer to the listening position, so that
the sound output from all speakers reach the
listening position at the same time.
•
[Speaker Volume] – Set the volume level of
the speaker and the subwoofer to get the ideal
audio balance.
•
[Speaker Size]
•
Set the speaker size for the speakers and
the subwoofer.
•
Select
[Large] size for speakers that can
produce low frequency signal below
120 Hz.
•
Select
[No Speaker] if there is no
speaker connected.
•
If the front speakers are set to
subwoofer setting is [On] and cannot be
changed.
•
If the subwoofer is set to
speakers settings are [Large] and cannot
be changed.
Tip
•
The test tone is emitted from the speaker while adjusting
the volume level.
Allow 1ms setting for every 30cm distance between
the speaker and the listening position.
Preference Setup
1
Press
.
2
Select [Settings], then press OK.
3
Select [Preference Setup], then press .
4
Select an option, then press OK.
5
Select a setting, then press OK.
•
To return to the previous menu, press
BACK.
•
To exit the menu, press
[Menu Language]
Select an on-screen menu language.
Note
•
If this product is connected to an HDMI CEC compliant
TV using an HDMI cable, it switches automatically to the
same menu display language as per your TV setting (if the
language set on TV is supported by this product).
[Parental Control]
Restrict access to discs that are unsuitable for
children. These types of discs must be recorded
with ratings.
To access, enter your last set password or '0000'.
[Small],
[Off], the front
.
EN
19
Advertisement
Table of Contents
