Philips AZ 8491 Manual page 6

COMPACT DISC
PLAYING A DISC
e Switch on the set with POWER switch (3.
e Set MODE selector (5) to CD (Compact Disc).
е Adjust the sound with the controls VOLUME (4) and
GRAPHIC EQUALIZER @) and the DBB bass button ©.
€ Press CD A (3) to open the disc cover.
e Fit the disc, label side facing up, over the spindle of the
tumtable (fig. 4).
e Close the cover. The CD-player starts and '-- —-- appears
on the display as a sign that the CD-player is scanning the
contents list of the disc. After that, the total playing time and
the number of tracks present on the disc appears on the
display and the CD-player stops.
e Playback will start by pressing PLAY >. As soon as
playback starts, the display shows the track number 1 and
the elapsed playing time of the 15t tile. When the 229 title is
reached the track number 2 appears, etc.
e For brief interruptions, press PAUSE 00. The word PAUSE
then appears. To continue playback, press PAUSE again.
€ The CD player goes to position STOP:
- by pressing STOP O or CD А (3);
— when the end of the disc is reached;
~ «уои move the MODE selector (5);
- if you switch off the set with POWER switch (3;
— if the batteries run down or if the power supply is
interrupted ín another way.
e lo take out the disc, open the disc cover by pressing CD
A (3.
e Always switch off the set after use with POWER switch (3).
Remarks
– The CD-playeris able to play the normal 12 cm disc as well
as the small 8 cm disc 'CD-single'. An adapter ring for 8 cm
CD-singles is not required.
- If the battery voltage is not sufficient any more for playing
a disc, the CD-player will not start.
—if the display shows the character E for ERROR, the
CD-player cannot read the disc. Possible causes are:
— you inserted the disc the wrong way (the label should
face up);
— the surface of the disc is badly scratched or dirty, see
'Maintenance';
– the lens (У) (fig. 5) is steamed up because of a sudden
transition from a cold into a warm environment; do not
clean the lens, but let the set acclimatize for a while.
INTROSCAN
The INTROSCAN function can be switched on both from the
STOP O and the PLAY E- position.
e Press INTROSCAN. The word SCAN then appears. Only
the first few seconds of each track on the disc are played,
but always from the 1St track number. After playing a few
seconds of one track, the CD player jumps to the next track.
The display always shows the corresponding track number.
e The moment that you press PLAY E», the INTROSCAN
function is defeated (the word SCAN disappears) and the
disc is played in the normal way from this track number.
e lí you press Ног , the INTROSCAN function remains
operative and the beginning of the next Plor previous М
track is played for a few seconds.
e If the INTROSCAN function ts not defeated by pressing
PLAY CG or STOP O, then the CD player automatically
returns to STOP as soon as the end of the disc ts reached
REPEAT
If you want to repeat the whole disc (or the stored selection)
continuously, press ihe REPEAT-button: the word REPEAT
appears on the display.
The REPEAT function can only be switched on during PLAY
С> or INTROSCAN.
To defeat the REPEAT-function, press REPEAT agam and
the word REPEAT disappears.