KYMCO UXV 450i EPS OFF ROAD Owner's Manual page 66

Maintenance And Lubrication
Battery Remove
1. Make sure the ignition switch is OFF.
2. Remove the hood.
3. Disconnect the negative (
(1) from the battery first, then disconnect
the positive (+) terminal lead (2).
4. Remove the battery.
Battery installation
1. Install in the reverse order of removal.
2. After installing the battery, check if the
battery cables are routed correctly.
NOTE:
First connect the positive (+) cable and then
negative (-) cable to avoid short circuit.
-
) terminal lead
63
(1)
(2)