Download Print this page
Leggett & Platt 190-0066 User Manual
Leggett & Platt 190-0066 User Manual

Leggett & Platt 190-0066 User Manual

Advertisement

Quick Links

Remote Control User Guide
190-0066
Increases Wave head
(Low, Med, High, OFF)
FLAT
SPECIAL:
SNORE
FOOT
Press to raise head to the preprogrammed position. Head
UNWIND
will automatically lower to flat after 15 minutes. If SNORE
is pressed again within this 15 minute period, head will
lower to flat position.
SLEEP
LUMBAR
WAKE
UP
Pressing any other button during this 15 minute
RELAX
period will cancel the snore timer and head will not
MASSAGE
FOOT
return to flat after 15 minutes.
Under Bed Light
(UBL) On/Off
Flashlight
Head Up/Down
Unwind Position
Pillow Up/Down
Wake Up Position
Head Massage
Increase/Decrease
Wave On/OFF
to foot frequency
NOTE
UBL
FLAT
SNORE
HEAD
FOOT
UNWIND
SLEEP
PILLOW
LUMBAR
WAKE
UP
RELAX
HEAD
MASSAGE
FOOT
UBL
UBL
HEAD
SNORE
HEAD
UNWIND
PILLOW
Press to raise base to the preprogrammed position.
SLEEP
Preprogrammed positions are reprogrammable
PILLOW
through the LP Comfort Connect mobile app only.
WAKE
UP
HEAD
RELAX
HEAD
MASSAGE
MASSAGE:
Maximum massage time is 15 minutes
Flashlight
Flat Position
Snore Position
Foot Up/Down
Sleep Position
Lumbar Up/Down
Relax Position
Foot Massage
Increase/Decrease
UBL
FLAT
UBL
SNORE
HEAD
FLAT
SNORE
UNWIND
HEAD
FOOT
FLAT
SNORE
UNWIND
SLEEP
FOOT
PILLOW
WAKE
UNWIND
SLEEP
UP
FOOT
PILLOW
LUMBAR
WAKE
SLEEP
RELAX
UP
LUMBAR
HEAD
MASSAGE
WAKE
RELAX
UP
LUMBAR
HEAD
MASSAGE
FOOT
RELAX
MASSAGE
FOOT
FOOT
FLAT
FOOT
LUMBAR
FOOT

Advertisement

loading
Need help?

Need help?

Do you have a question about the 190-0066 and is the answer not in the manual?

Questions and answers

Lynne
March 12, 2025

I need a replacement remote for 190-0066.

Subscribe to Our Youtube Channel

Summary of Contents for Leggett & Platt 190-0066

  • Page 1 Remote Control User Guide 190-0066 Flashlight Flat Position Under Bed Light (UBL) On/Off Snore Position FLAT Flashlight Foot Up/Down SNORE Head Up/Down HEAD FOOT Sleep Position UNWIND Unwind Position Lumbar Up/Down SLEEP Pillow Up/Down PILLOW LUMBAR WAKE Relax Position Wake Up Position...
  • Page 2: Remote Control Programming

    Remote Control Programming FLAT SNORE HEAD FOOT UNWIND SLEEP 1 REMOTE TO OPERATE 1 BASE PILLOW LUMBAR WAKE RELAX HEAD MASSAGE FOOT Plug base into power outlet. NOTE You now have 2 minutes to complete the programming procedure. Remove battery compartment door on back of remote then install 3 AAA batteries.
  • Page 3 Remote Control Programming FLAT FLAT SNORE SNORE HEAD FOOT HEAD FOOT 1 OR 2 REMOTES TO OPERATE 2 BASES UNWIND UNWIND SLEEP SLEEP PILLOW LUMBAR PILLOW LUMBAR WAKE WAKE RELAX RELAX HEAD MASSAGE FOOT HEAD MASSAGE FOOT Plug both bases into power outlet. Operate Unplug both bases and place them on their each base with its respective remote control sides close to each other.
  • Page 4: Power Down Operation

    Power Down Operation NOTE Use this procedure to lower the base to flat during a Power down device uses 9-volt alkaline power outage. Do NOT put batteries in power down batteries, which are not included. device until necessary for use. Unplug power brick from Insert (2) 9-volt alkaline batteries PWR port on control box.
  • Page 5: Troubleshooting

    Troubleshooting If the adjustable base fails to operate, investigate the symptoms and possible solutions provided in the chart below: SYMPTOM SOLUTION Program the remote control (see Remote Control Programming section of this manual for programming procedures). Unplug power cord, wait 30 seconds and plug in to reset electronic components.
  • Page 6 De-Syncing Your Remote REPROGRAM 1 REMOTE TO 1 BASE Simultaneously press and hold both the Simultaneously press and hold both the HEAD HEAD UP and FOOT DOWN buttons on DOWN and FOOT UP buttons on the remote the remote control for 3 seconds. control.
  • Page 7 Advisory IMPORTANT INFORMATION READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT SERVICE REQUIREMENTS WARNING Service technicians are not responsible for moving furniture, removing headboards and footboards or FOR OPTIMUM ADJUSTABLE BASE any items required to perform maintenance on the OPERATION, USE A GROUNDED, ELECTRICAL base.
  • Page 8 Advisory IMPORTANT INFORMATION READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT SMALL CHILDREN / PETS WARNING FCC COMPLIANCE After the base is unboxed, immediately dispose The equipment has been tested and found to of packaging material as it can smother small comply with the limits for a Class B digital device, children and pets.