Table of Contents
Advertisement
• Disconnect
from
the
E F fixing knob
Cable clamp
Fig. 2-1-4
Fig. 2-2-1
Remove three screws
Remove three screws
Fig. 2-1-5
Fig. 2-2-2
Remove the top cover
Fig. 2-2-3
Fig. 2-1-6
2
•
Hook
both PCBs onto the
PCB
holding edges
of
the
chassis to
fix both
PCBs
firmly.
(Fig.
2-1-6)
Note:
When reinstalling the process circuit board,
make sure that the insulating washers are
attached at the PCB.
(B) For right side PCB (viewed from the front)
Process Circuit Board (YW 3110PZK2)
•
Remove the three screws on the bottom and remove
the top cover.
® Remove three screws which hold the printed circuit
board (PCB) in order to gain access to the desired
circuitry.
(A) For left side PCB (viewed from the front)
Deflection Circuit Board (YW 3110PZK 1)
Remove three screws
camera.
• Remove viewfinder cable from the cable clamp,
loosen the E F fixing knob and remove the view
finder from the mounting bracket. (Fig. 2-2-1)
Note:
The viewfinder can be disassembled without
removing it from the camera.
2-2.
iewfinder Unit
the
viewfinder
connector
Advertisement
Table of Contents
