Table of Contents
Advertisement
7. CONTROL PANEL REMOVAL
Remove two screws
Remove one screw
CN103
Handle cover A
Remove one screw
Fig. 7-8
Fig. 7-11
Fig. 7-4
Remove two screws
Fig. 7-1
Remove one screw
Red --------
Remove two screws
Fig. 7-5
Fig. 7-12
Fig. 7-9
Remove four screws
Move the upper cover
Fig. 7-2
Fig. 7-6
Fig. 7-10
Remove one screw
Handle cover B
Fig. 7-7
Fig. 7-3
24
25
•
Remove the MIC holder by removing the two fixing
screws. (Fig. 7-2)
• Remove the E F mounting base by removing the one
fixingscrew. (Fig. 7-3)
Remove
one screw
•
Remove the four screws on the bottom cover and
remove the cover. (Fig. 7-6)
•
Remove the one screw on the handle cover B and
remove the handle cover B (Fig 7-7)
Note:
When reinstalling the indicating plate, place it
on
the standby power switch that its red por
tion is at the left side. (Fig. 7-5)
®
Remove the one screw by the E F connector and
move the upper cover as shown below.
So that the control panel fixing screws can be ob
served. (Fig. 7-9, 7-10)
Note:
• When installing the control panel to the control panel
base, set the indoor/outdoor switch and the white
balance switch on the control panel to the upper posi
tion for proper engagement.
• When installing the control panel with the control
panel base to the chassis, set the indoor/outdoor
switch to the upper (OUTDOOR) position and the
white balance switch to the lower (SET) position for
proper engagement.
•
Remove the two screws on the control panel and
remove the control panel from the chassis. (Fig. 7-11)
•
Remove the two control knobs, and the two screws
on the control panel base for removing the control
panel from the base. (Fig. 7-12)
Remove
four screws
IB
•
Remove the one screw on the handle cover A and
remove the handle cover A. (Fig. 7-8)
•
Remove the rear cover by removing the four fixing
screws. (Fig. 7-4)
• Disassemble
the
camera
and
the
viewfinder as
described
in
Section
2.
"DISASSEMBLY
PRO
CEDURE FOR ADJUSTMENT" on page 1.
• Disconnect the connector CN103 for the microphone
from the deflection circuit board, and remove the
microphone unit by removing the one fixing screw.
(Fig. 7-1)
Advertisement
Table of Contents
