Noise/Vibration Information; Working With The Device - Proxxon MICROCUTTER MIC Manual

Saw blade rotational speed:
Max. saw blade diameter:
Noise generation:
Vibration:

5 Noise/vibration information

The information on vibration and noise emissi-
on has been determined in compliance with the
prescribed standardised and normative measu-
ring methods and can be used to compare elec-
trical devices and tools with each other.
These values also allow a preliminary evalua-
tion of the loads caused by vibration and noise
emissions.
Warning!
Depending on the operating conditions while
operating the device, the actually occurring
emissions could differ from the values speci-
fi ed above!
Please bear in mind that the vibration and noise
emission can deviate from the values given in
these instructions, depending on the conditions
of use of the tool. Poorly maintained tools, in-
appropriate working methods, different work
pieces, too high a feed or unsuitable work pi-
eces or materials or unsuitable bits and cutters
(here: saw blade) can signifi cantly increase the
vibration load and noise emission across the
entire work period.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched off,
or is running but is not actually in use. This can
clearly reduce the vibration and noise load ac-
ross the entire work period.
Warning!
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
20,000/min
23 mm
< 70 dB(A)
2
≤ 2,5 m/ s
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable
bits and cutters!
• Take breaks if necessary when working with
the device!
6 Commissioning
Your Microcutter MIC is ready for use when deli-
vered and does not require special commissioning
measures. However, each time before you begin
work, check the device for signs of obvious dama-
ge and make sure that the automatic saw blade
cover works correctly and swings back automa-
tically to the home position whenever the device
is not in use.
Always ensure your own safety. Despite its
compact size, the Microcutter MIC is an electric
tool that poses a certain risk. Always make sure
to disconnect the mains plug when you check
the device, clean it or replace the saw blade!

7 Working with the device

Attention!
For your own safety, wear protective goggles
and hearing protection when you work with the
device!
Attention!
While working, make sure the work piece is
held securely! Flying work piece parts pose a
hazard!
Attention!
Never press the lock button when the device
is switched on. This would cause mechanical
damage!
Warning!
Please make sure that the saw blade is in a
perfect condition and is not worn or dama-
ged. Worn or damaged saw blades can break
or place a great load on the mechanics while
working. Risks of injuries or technical defects
- 9 -