Description; Purpose; Overview; General Power Tool Safety Warnings - GreenWorks BLC463 Operator's Manual

EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard.
1.2

OVERVIEW

Figure 1 - 5.
1 Turbo button
2 Cruise control lever
3 Trigger
4 Front blower tube
5 Rear blower tube
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
3

INSTALLATION

3.1

INSTALL THE TRIGGER HANDLE

Figure 2 -3.
1. Move the trigger handle (11) onto the connecting
tube (6).
2. Use knob to tighten the screw.
3.2

INSTALL THE CONNECTING TUBE

Figure 4 - 6.
1. Align the rib (12) on the connecting tube with the
slot (13) in the flexible tube.
2. Put the end of the connecting tube (6) into the
flexible tube.
3. Push the connecting tube into the flexible tube.
4. Put the hose clamp (14) around the flexible tube.
5. Install and tighten the available screw into the hose
clamp (14).
3.3 INSTALL THE REAR BLOWER
TUBE
Figure 7 - 8.
6 Connecting tube
7 Battery release
button
8 Battery compartment
9 Harness
WARNING
English
1. Align the grooves on the rear blower tube (5) with
the tabs on the connecting tube (6).
2. Turn the rear blower tube in the direction of the slot
until the tabs lock into position.
Put the cord in the cord retainer.
3.4 INSTALL THE FRONT BLOWER
TUBE
Figure 9 - 10.
1. Align the grooves on the front blower tube (4) with
the tabs on the rear blower tube (5).
2. Install the front blower tube onto the rear blower
tube until the tabs engage the grooves.
3. Turn the front blower tube in the direction of the slot
until the tabs lock into position.
The front tube has two fixed positions. You can adjust
the length of the tube according to different needs.
3.5

ADJUST THE HARNESS

Figure 12 -15.
1. Fit the backpack on your back.
2. Pull the ends of the straps down to tighten the
harness.
3. Connect the horizontal chest strap.
4. Pull the end of the chest strap to tighten.
5. Lift the tabs of the adjusters to loosen the straps.
6. Lock the quick-release fastener by pushing it
together.
7. Squeeze the hooks to open the quick-release
fastener.
Install the back pad against your back tightly and
safely.
3.6

REMOVE THE HARNESS

1. Open the quick-release fasteners on the chest strap.
2. Loosen the harness straps by lifting the sliding
adjusters and then take off the machine.
In the event of imminent danger, quickly remove the
machine. Release the chest strap before you put the
machine on the ground.
4
WARNING
NOTE
NOTE
WARNING