Kenwood TS-850S Instruction Manual page 34

MODE key
ssired Press the LSB/USB key to
vit.
are between LSB and
NB switch/control
es
NB1 : For pulse type
noise,
:
such as generated
by
5
h,
filter
RIT/XIT switch/control
automaine
ignition
systems.
ni cate sca
NB2: Noise blanker 2 is
NOTCH switch/control
used for long duration
pulse noise, like the
"woodpecker".
RF gain control
This control should be all the
way to the right.
TONE control
Turn the control to increase
or decrease the tone.
SLOPE TUNE control
M.CH/VFO CH control
This control is used to
change the frequency in 10 LINEAR AMP switch
;
kHz steps during
=VFO Activates the relay for the |__
1
he tuning | | operations.
linear amplifier control. If the
z (1 Hz] | This control is also used to
linear amplifier relay operates
ling.
select the desired memory
slowly,
you
may
need to
ACC 2 connector
channel
during == Memory
make a retry. Check
the
Connect the data communica-
Channel Operation.
TNC parameter setting.
tions devices.
(TRANSMISSION)
Connect the communication
terminal signal
line to the ACC 2 | Connect the ACC 2 connector.
connector on the rear.
Standby
Turn on the DC power supply and then turn the transceiver's power
Moduration
switch ON.
output:
A frequency is shown in the display.
E@ Select LSB or USB with the MODE key. 33
Enter the desired frequency.
Before transmitting check the frequency for activity so that you do
AF INPUT
not interrupt another QSO.
Press the METER key until the ALC meter lights.
Ae
Notes