Cw Operation - Kenwood TS-850S Instruction Manual

4-4. CW OPERATION | PLAY, REC keys ae
Records and plays CW Used
messages for transmission. mete
AIP switch
When switched on, _ it ATT switch FILTI
reduces interference from This switch allows Char
strong signals. attenuation of the input selec
signal by 6, 12 or 18 dB.
FULL/SEMI switch
During CW operation, selects
either Full Break-in (FULL) or
Semi Break-in (SEMI).
VOX/MAN switch
Used to select Break-in
Reduces output power for linear LHe
PITCH key amplifier adjustment.
Select the CW receive tone.
operation.
THRU/AUTO switch
THRU: Antenna tuner is off.
AUTO: Antenna tuner is on. E
AGC switch = =
Set
to MID or FAST
zy
normally.
-
|
PWR control
KEY SPEED control Power can be controlled in Fr
This control the speed of the all modes. |
electronic keyer.
Z TUNE key \!
Outputs a zero beat in iF
receive mode.
|
(RECEIVING)
Turn on the DC power supply and then turn the transceiver's power switch ON.
a
A frequency is shown in the display.
Press the UP/DOWN switches to select the desired frequency band.
When the 1 MHz step position is selected, the MHz indicator will light.
AAP SA
[4] Select CW with the MODE key.
[5] Turn the AF gain control clockwise until a signal or noise is heard.
[6] Rotate the TUNING knob and select an open channel.
22