Advertisement
Assemble loose end of belt
8.
on left side of rail (C), under lip (M) of guide rail and fasten
(L)
to side of carriage (G) by repeating STEPS
belt
ASSEMBLING PATTERN
SUPPORT BRACKETS
TO DUPLICATOR RAIL
Slide pattern support bracket (A) Fig. 9, into bottom
1.
channel of duplicator rail
(8)
2.
1- 1/2
Thread
inch-long screw
of pattern support bracket (A). Adjustments can be made
later.
3.
Assemble remaining pattern support bracket to oppo-
site end of duplicator rail in the same manner.
ASSEMBLING PATTERN
HOLDING BRACKETS
TO DUPLICATOR RAIL
Slide pattern holding bracket (A) Fig. 10, into bottom
1 .
channel of duplicator rail
(8)
Adjustments can be made later.
2.
Assemble remaining pattern holding bracket to oppo-
site end of duplicator rail in the same manner.
ASSEMBLING
FOLLOWER ARM TO
CARRIAGE ASSEMBLY
Insert follower arm (A) Fig.
carriage assembly and tighten thumb screw (C).
Pin
(D)
of follower arm (A) should point toward right end
of duplicator rail (E).
(L)
Fig.
8 ,
around guide
5
and
and tighten two screws (C).
(D)
with locknut into face
and tighten two screws (C).
into hole in arm
(8)
of
11,
NOTE:
6.
3
8
Fig.
Fig. 9
Fig.
10
Fig.
1 1
Advertisement
