Advertisement
3.
Slide carriage (G) Fig.
by engaging two guides
(H)
carriage (G) into gear rack (K). Replace belt guide and
screw that were removed in STEP 1 to right side of
duplicator rail (C).
Remove two screws and washers
4.
(E) and retainer plate (F) from each side of carriage (G).
Place one end of belt (L), Fig.
5.
and cover with retainer plate (F).
of belt (L) must be positioned with, or slightly below right
side of wiper (E) as shown.
6.
Line up holes in wiper (E) Fig.
(F) with two holes on side of carriage (G) and fasten belt
(L) to carriage with two 1/ 2 inch-long socket head screws
and flat washers
(0).
Assemble belt (L) Fig.
7.
rail and around guide (8). Pass belt (L) inside and through
duplicator rail (C) and out the other end of duplicator rail.
Make certain belt is not twisted inside
IMPORTANT:
duplicator rail.
onto duplicator guide rail (C)
4
into channels
(J)
and sliding
(0),
Fig.
5,
wiper
on wiper (E) as shown
6,
Cut-out section
NOTE:
and retainer plate
7,
under lip (M) of duplicator
7,
2
Fig.
4
Fig.
5
Fig.
6
Fig.
7
L
Advertisement
