Table of Contents
Advertisement
3. Select Edit from the Gauge sub menu.
NOTE: The Available Gauges dialog box appears.
4. In the Available Gauges dialog box, do ONE of the following:
•
Select an existing gauge, then click the Edit button
•
Click the Add button to create a new primary gauge definition.
NOTE: The Properties dialog box appears.
5. In the Units field, select the units to appear in the gauge. Options are:
•
Pounds force (PSI)
•
kiloPascal (kPa)
•
Barometric (Bar)
•
megaPascal (MPa)
6. In the Lower Limit and Upper Limit fields, type the minimum and maximum pressure
values for the gauge.
7. Enter values in the Start From and Stop At fields to set the orientation for the gauge.
NOTE: The Start From field and Stop At field describe where on the gauges
display the Lower Limit value starts and the Upper Limit value stops. The
values are any number from 0 to 12, and they represent the numbers on the face
of a clock. For example, 1 represents the one o'clock position, 3
represents the three o'clock position, and 9 represents the nine o'clock position.
Both 0 and 12 represent the twelve o'clock position. If the position wanted
is between the five and the six o'clock position, enter the value 5.5. In between
the twelve o'clock and the one o'clock position enter a value of 0.5.
The defaults are set to 6 o'clock.
Property of DataCan Services Corp. No duplication or distribution without written consent
Property of DataCan Services Corp. No duplication or distribution without written consent
44
Advertisement
Table of Contents
