Advertisement
KR-V126R
CONTROLS AND INDICATORS
ovat
character
[MEMORY]
ale:
aH
SL
|
@ POWER
switch
Press this switch to turn on power. (The POWER
STAND
BY indicator lights.) Press it again to turn power off.
@ SPEAKERS A and B switches
A.B OFF - This position silences all speakers to permit
private use of headphones.
A ON - Activates speakers connected to the SPEAKERS
A terminals on the rear panel.
B ON - Activates speakers connected to the SPEAKERS
B terminals on the rear panel.
A,B ON - Activates speakers connected to the SPEAK-
ERS A and B terminals simultaneously.
Note:
When the SPEAKERS A and B switches are used at the same time,
the speakers connected to the SPEAKERS A and B terminals are
connected in series. In this respect. whenever using the SPEAK-
ERS
A and B switches at the same time, be sure that two pairs
of speakers are connected to the terminals A and B, otherwise no
sound is output.
© PHONES jack
Stereo headphones are plugged into this jack.
© EQ (Equalizer) PRESET keys
Use these keys to store equalizer curves in memory or to
recall them.
PGM.: User-adjusted equalizer curves can be programmed
as desired and stored in memory: up to five patterns.
SET: Five factory-preset
equalizer curves
are stored
in
memory.
Upto 10 equalizer curve memories are available in total.
Press the
PGM/SET
key to select
either
the
user-
programmed
pattern or the factory-preset pattern.
©
Equalizer level controls
Adjust these controls up and down to equalize the sound
by +12 dB to the center frequency indicated.
© EQUALIZER
key
Press this switch to ON and the frequency characteristic
will be modified by passing through the graphic equalizer.
In the
DEFEAT
position,
the
frequency
characteristic
remains unchanged.
@ EQ REC key
Used
when
recording
the source
onto
the tape
deck
through the equalized response of the graphic equalizer.
© EQ PRESENCE
controls
Adjust these controls (INCREASE and DECREASE) to boost
or attenuate the equalizer curve indicated.
© PGM/SET
key
Pressing this key alternates the preset equalizer curves to
be recalled between PGM (user-programmed patterns) and
SET (factory-preset patterns) groups.
@ Equalizer preset MEMORY
key
This key is used to store an equalizer curve into the PGM
PRESET memories. First, select the desired equalizer curve
and then press this key. Then press any of the PRESET (A
to E) keys. The selected equalizer curve will be stored in
the memory
indicated by the PRESET key pressed.
@ EQ/SPI key
Pressing this key alternates the display mode between the
EQ (graphic equalizer) and SPI (spectram peak indic ator-
spectrum analyzer).
@® PEAK HOLD ON/OFF key
In the spectrum analyzer display (SPI) mode, pressing this
key activate or deactivate the Peak Hold function of the
power meter indicator.
Advertisement
