Table of Contents
Advertisement
1. Transport with the three-point hitch attachment of the tractor
Attach the machine with the three-point hitch and lift it with the hydraulic system of the
tractor.
If the rear tractor lights are covered, a warning light must be installed at the back side of
the machine (e.g. magnet support, portable lamp).
When transporting the machine on public roads, follow road traffic regulations.
Maximum transport speed: 40 km/h
If the machine is lowered on the ground, make sure it is placed on a level and solid surface.
Obligatory use of slow moving vehicle signalization – check the local laws on road traffic
regulation (Rules on devices and equipment of vehicles).
2. Transport with the machine chassis
When the machine is transported, it is necessary to use the lower link.
Before transportation, the support legs must be moved into the uppermost position.
If the rear tractor lights are covered, a warning light must be installed at the back side of
the machine (e.g. magnet support, portable lamp ...).
Obligatory use of slow moving vehicle signalization (Rules on devices and equipment of
vehicles).
Test the operation of the lamp.
When the machine is transported on public roads, the road traffic regulations must be observed.
Maximum transport speed: (10 or 25 km/h) – comply with local regulations!
If the machine is lowered on the ground, make sure it is placed on a level and solid surface.
CONTROL INTERVENTIONS
Before starting any control interventions, always turn off the machine.
Disconnect the machine from the power source or disconnect the cardan shaft!
1. Protective devices
The machine must be fitted with all protective devices (covers, protective grids etc.).
2. Threaded fittings
After the first hour of operation, tighten all screws and nuts.
After every 100 operating hours, retighten all screws and nuts.
Replace any missing screws and nuts.
3. Hydraulic hoses
After the first hour of operation check the sealing and fastening of all hydraulic hoses.
The sealing and fastening of hydraulic hoses must be checked after every 100 operating hours.
Immediately replace any damaged hydraulic hoses!
4. Saw blade
Before each use, check if the saw blade is fastened correctly.
Before each use, check if the saw blade is worn or damaged and sharpen or replace it, if
necessary.
22
Advertisement
Table of Contents
