Table of Contents
Advertisement
| PRECAUTIONS
If it becomes necessary to transport or ship this unit in
the future, be sure to first remove the disc (if loaded),
retract the disc table to its closed position and turn the
power off. After the ''OFF'' indicator stops blinking on
the display, disconnect the power cord. Then insert and
tighten the transit screw.
Take the following precautions to avoid accidents!
Be careful not to catch your finger in the disc table sec-
|
tion while the disc table is being retracted into the unit,
j
Also, be careful that children do not put their hands into
the inside of the unit while the disc table is open. This
may cause injury.
INSTALLING THE PLAYER
® Place the player on a stable platform next to the televi-
sion and stereo system to be used with the player.
@ When using the player with a stereo system, your speak-
ers should be placed away from your television (or TV
monitor).
® Do not place heavy objects such as a television or TV
monitor on top of the player.
@ Do not place the player on top of your TV set or TV mo-
nitor. Also, keep the player away from devices such as
cassette decks which are sensitive to magnetic fields.
When FM or AM stations are being received, signal noise
may be generated if the player is turned on. Turn off the
player when not in use. Also, if there is signal noise when
receiving radio stations with an indoor antenna, adjust the
position or direction of the antenna.
INSTALL THE PLAYER IN A WELL-VENTILATED
PLACE AWAY
FROM HEAT AND HUMIDITY
Do not install the player in a location subject to direct sun-
light, or near a stove or radiator etc. This could adversely
affect the cabinet and internal components. Also avoid in-
stalling the player in a humid or dusty location. This could
result in a malfunction or accident. Do not install near a cook-
stove where the player could be affected by smoke, steam,
or heat.
AVOID SOURCES OF HEAT
Do not put the player on sources of heat, such as an ampli-
fier. When installing with audio components on a rack, avoid
components that generate heat, by placing the player be-
low such components where there is adequate ventilation
and not much dust. Avoid placing the player on surfaces
such as shaggy carpets, beds, and sofas which may block
ventilation under the player and cause damage.
Even when the player is in the pause mode, the disk motor is |
6
<VRB1067>
CONDENSATION
Moisture will form in the operating section of the player
if the player is brought from cool surroundings into a
warm room or if the temperature of the room rises sud-
denly. When this happens, player's performance will be
impaired.
To prevent this, jet the player stand in its new surround-
ings for about an hour before switching it on, or make
sure that the room temperature rises gradually.
The same symptoms of condensation may be caused dur-
ing summer, if the player is exposed to the breeze from an
air conditioner.
in such cases change the location of the
player.
POWER-CORD CAUTION
Handle the power cord by the piug. Do not pull out the plug
by tugging the cord and never touch the power cord when
your hands are wet as this could cause a short circuit or
electric shock. Do not place the unit, a piece fo fumiture,
etc., on the power cord, or pinch the cord. Never make a
knot in the cord or tie it with other cords. The power cords
should be routed in such a way that they are not likely to
be stepped on. A damaged power cord can cause fire or give
you an electrical shock. Check the power cord regularly.
When you find it damaged, ask your nearest PIONEER autho-
rized service center or your dealer for a replacement.
ee
ee
ee
CLEANING CARE
——————_
Use a soft, dry cloth for cleaning. For, stubborn dirt. soak
the cloth in a solution of household detergent diluted using
1 part detergent to five or six parts water; wring well first
and wipe. Use a dry cloth to wipe it dry. Do not use any
volatile agents such as benzine or paint thinner, as they may
damage the surface of the player.
Abnormal
functioning
of this unit may
be caused
by
lightning, static electricity, or other external interference.
To restore normal operation, turn the power off and then
on again, or unplug the AC power cord and then plug it
in again.
Advertisement
Table of Contents
