Operation - Nitto Kohki MAH-05 Instruction Manual

3-3. Lubrication
tool.

4. OPERATION

4-1. How to replace tip tool
Warning
Turn off the Valve and disconnect the air hose
●
before replacing tip tool.
Tighten
Loosen
SleeveΦ3
Tip tool
4-2. Start and Stop
Caution
If the tool does not start after turning the Valve
●
on,
(1) Turn the Valve off and disconnect the air hose
from the air supply line.
t h e H e x . S o c k e t
Screw on the Guide
Shaft from the Guide
H o l d e r a n d t u r n i t
back. (Fig.3)
(3) Dispense 5 drops of ISO VG-10 machine tool oil
into the air hose of the tool.
(4) Reconnect the air hose to the air supply line
and turn the Valve on.
●
●
Holder and the Hex. Socket Set Screw faces the
same direction.
Take care not to get injured by chips or shavings
●
Hex. Socket Screw Key 2
Guide Holder
Guide Shaft
File
Hex Socket Screw
the air hose into the Cupla of the this tool.
ON
ON-OFF Display
4-3. Grinding and polishing operations
Warning
Be sure to wear protective glasses and a
●
dustproof mask during operation.
4-4. Storing Tool
Warning
When tool is not used, store it out of reach of
●
children.
OFF
Valve