Table of Contents
Advertisement
Only activate and use transport level to
#
load the vehicle and when not on public
roads.
Ensure that no persons or obstacles are
#
located in the area surrounding the vehi-
cle.
Raising the vehicle to transport level
Press the G button for at least five sec-
#
onds.
Immediately press and hold the a button
#
for at least one second.
The
For Transport Level Switch On Vehicle
message will be displayed.
Select
vehicle
transport.
#
%
Noise certification mode is intended exclu-
sively for the technical test organization. It
restricts the drive power of the vehicle and
must not be used in customer operation.
Switch on the vehicle (
page 194).
/
#
The transport settings will be displayed.
Swipe downward to select
Transport Level
#
and press a.
The vehicle will be raised and the
ing... Do not drive onto ramp yet
be displayed for five seconds. The raising
process may last up to 60 seconds and can be
canceled with the G button.
When raising, do not switch off the vehicle.
#
While the vehicle is being raised, you can maneu-
ver at a maximum speed of 25 mph (40 km/h).
Before loading the vehicle, wait until the trans-
#
port level has been reached and the
port Level
status is shown.
%
If the vehicle is raised to transport level, the
transport settings will continue to be shown
even after a restart. Operation of the driver's
Vehicle rais-
display will be restricted.
message will
When the vehicle is at transport level, it will be
lowered again in the following situations:
When you drive at a speed greater than
R
25 mph (40 km/h).
The 12 V battery is discharged.
R
The vehicle will be adjusted to the height of the
last active level.
Transporting the vehicle
* NOTE Damage to the vehicle from secur-
ing it incorrectly
After loading, the vehicle must be
#
secured on all four wheels. Otherwise,
the vehicle could be damaged.
A minimum distance of 8 in (20 cm)
#
upwards and 4 in (10 cm) downwards
must be kept to the transport platform.
Trans-
Breakdown assistance 405
Advertisement
Table of Contents
