Connect To The Internet; Interface Type - Dhcp - ZyXEL Communications USG FLEX H Series User Manual

Figure 18 Terms of Use/Privacy Policy/Mandatory Firmware Upgrade Notification

2.3 Connect to the Internet

Use this screen to set the interface's type of encapsulation and method of IP address assignment.
The screens vary depending on the encapsulation type. Refer to information provided by your ISP to
know what to enter in each field.
Go to Network > Interface after you log into the web configurator if you want to change the interface
settings.
Note: Enter the Internet access information exactly as your ISP gave it to you. Leave a field
blank if you don't have that information.

2.3.1 Interface Type - DHCP

Use this screen to configure your IP address settings.
• Interface Type: This displays the type of Internet connection you are configuring. Select DHCP if your
ISP did not assign you a fixed IP address.
• Port: Select a port to apply the Internet connection settings to.
• IP Address: This field is read-only when you set Interface Type to DHCP.
• DHCP Option 60: DHCP Option 60 is used by the Zyxel Device for identification to the DHCP server
using the VCI (Vendor Class Identifier) on the DHCP server. The Zyxel Device adds it in the initial DHCP
discovery message that a DHCP client broadcasts in search of an IP address. The DHCP server can
assign different IP addresses or options to clients with the specific VCI or reject the request from clients
without the specific VCI.
Type a string using up to 63 of these characters a-zA-Z0-9!\"#$%&'()*+,-./:;<=>?@[]^_`{}to identify this
Zyxel Device to the DHCP server. For example, Zyxel-TW.
• VLAN Tag: Enable to tag the traffic going out from the Zyxel Device
Chapter 2 Initial Setup Wizard
USG FLEX H Series User's Guide
34