Table of Contents
Advertisement
PTO 540 / 540E rpm model (if equipped)
BPTO Gear Shift Lever
To avoid personal injury or death:
A Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
The PTO gear shift lever can be set to either 540 rpm or
540E rpm positions.
Move this lever to either position with the PTO clutch
control switch set to "OFF".
(1) PTO gear shift lever
A For
maximum
PTO
implements, see the implement Operator's Manual.
A Whenever the PTO speed is changed to the other
speed, it is necessary to switch the PTO speed display
mode of the side digital display. Otherwise the PTO
speed will not get correctly displayed in the side digital
display.
(See
"SIDE
"OPERATING THE TRACTOR" section.)
(A) 540 rpm
(N) "NEUTRAL POSITION"
(B) 540E rpm
shaft
speeds
of
various
DIGITAL
DISPLAY"
Shiftable PTO (540 / 1000 rpm) model (if equipped)
B1000 rpm PTO Shaft
To avoid personal injury or death:
A Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
By interchanging the PTO shafts, two different PTO shaft
speeds can be obtained.
(1) PTO shaft
(2) Snap ring
C PTO shaft interchanging procedure
1. The 6-spline 540 rpm PTO shaft is standard
equipment.
2. Place an oil pan under the PTO shaft to catch oil
spillage. Remove the snap ring, and then the PTO
shaft.
3. Install the 21-spline PTO shaft (1000 rpm). To ensure
that it is tight, push it in by turning.
4. Reinsert the snap ring.
5. Set the distance from drawbar pin hole to the rear end
of PTO shaft according to the following instructions.
in
A For
maximum
implements, see the implement Operator's Manual.
A Whenever the PTO speed is changed to the other
speed, it is necessary to switch the PTO speed display
mode of the side digital display. Otherwise the PTO
speed will not get correctly displayed in the side digital
display.
(See
"OPERATING THE TRACTOR" section.)
PTO
(A) 540 rpm PTO shaft
(B) 1000 rpm PTO shaft
PTO
shaft
speeds
of
"SIDE
DIGITAL
DISPLAY"
75
various
in
Advertisement
Table of Contents
Troubleshooting
