How To Update Firmware - Pioneer SC-65 Service Manual

5
[Case of Abnormal Completion]
If REGION File writing did not complete normally, an error number is displayed rather than the model number.
Please perform rewriting based on the coping strategy by error numbers below.
FL Display Examples
E R R O R R 0 1
E R R O R R 0 3
E R R O R R 0 4

8.4 HOW TO UPDATE FIRMWARE

Workflow
Enter the UPDATE PANEL mode.
Check a current version.
Update it.
Update completed.
(Turn the power OFF automatically.)
Enter the UPDATE PANEL mode again.
Check an updated version.
Turn the power off.
(Release the UPDATE PANEL mode.)
MAIN com (EMMA), SUB com (EVENT) , DSP Flash ROM and BridgeCo IC Update
by USB Memory and the Confirmation of the Version
UPDATE PANEL Mode (Version update)
[Preparations]
1. Copy the UPDATE FILE to the root directory of the USB Memory.
Note: NEVER copy several UPDATE FILES to the root directory of the USB Memory.
Copy only the corresponding UPDATE FILE.
2. Turn off the power to this unit by setting Multi-Zone to "OFF".
3. Connect the USB Memory to the USB terminal (A type) of the front panel.
[Procedures]
1. While holding down "TUNE↑" key on the front panel, press "STANDBY ON/OFF" key and
moves to the UPDATE PANEL mode.
2. The updating process is as follows.
5
6
Reason for Display
. Case of unsuccessful USB Read-in
. Case of No File for Writing
Case of destroyed File
Case of destination information for
different model is written
Updating process
Checking process
SC-65
6
7
Coping Strategy
. Try writing with other USB Memory
. Place writing required REGION File
to root directory
Download REGION File again
Download REGION File for correct
model
7
8
A
B
C
D
E
F
71
8