Cleaning And Maintenance; Disposal And Recycling - EINHELL GP-LB 18/200 Li E Operating Instructions Manual

6.2 Speed control (Fig. 5)
The equipment comes with electronic speed
control for setting the continuous blowing velocity.
Four blowing velocity levels are possible.
1. Switch on the equipment (section 6.1). The
equipment will blow at its lowest level. One
bar will appear on the display (6).
2. You can increase the blowing velocity by
pressing the SPEED button (7). Bars appear
on the display (6) according to the selected
blowing velocity.
1 bar = lowest blowing velocity.
4 bars = highest blowing velocity.
3. If you press the SPEED button (7) again when
the highest blowing velocity is active, the
equipment will return to the lowest blowing
velocity.
Use the equipment only with the blowing
velocity needed for the job.
6.3 Turbo mode (Fig. 5)
If you need a higher blowing velocity for a short
time, you can press and hold the TURBO button
(8). Pressing and holding the TURBO button
will increase the speed, providing the maximum
blowing velocity. All the bars will appear in the
display (6). Important: To minimize noise and
maximize battery operating time, you should
not press the TURBO button any longer than
necessary.
6.4 Blowing foliage
•
Turn on the equipment (see section 6.1).
•
Set the desired blowing velocity with the
speed controller (see section 6.2).
•
Direct the air stream forward and walk slowly
to blow foliage or garden refuse into a pile or
to remove it from hard-to-reach places.
•
To increase the blowing velocity for a short
time, use TURBO mode (see section 6.3).
Danger!
Never gather (blow) hot, combustible or explosive
materials into piles.
Anl_GP_LB_18_200_Li_E_SPK7_USA.indb 11 Anl_GP_LB_18_200_Li_E_SPK7_USA.indb 11
EN

7. Cleaning and maintenance

HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Maintenance
•
Should the tool experience problems
beyond those mentioned above, let only an
authorized professional or a service center
perform an inspection.
•
There are no other parts inside the equipment
which require maintenance.

8. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 11 -
21.09.2023 11:01:28 21.09.2023 11:01:28