Operation; Cleaning, Maintenance And Ordering Spare Parts - EINHELL TE-CB 18/180 Li Operating Instructions Manual

point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.4 Battery capacity indicator (Fig. 4/Item C)
Press the button for the battery capacity indicator
(B). The battery capacity indicator (C) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.

6. Operation

6.1 On/Off switch (Fig. 1/Item 2)
Switching on:
To switch on, press and hold the On/Off switch
(2).
Switching off :
Release the ON/OFF switch (2)
6.2 Speed control (Fig. 1)
The equipment has two speed settings. To select
a speed, push the selector switch (4) into the
desired position (1 or 2).
Anl_TE_CB_18_180_Li_SPK7_THA.indb 15 Anl_TE_CB_18_180_Li_SPK7_THA.indb 15
EN
Note:
Activate the selector switch (4) only when the
equipment is at a standstill.
7. Cleaning, maintenance and
ordering spare parts
Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering spare parts and accessories
Please contact the dealer that near home or
contact through company www.zinsano.com
LINE : @zinsano
or scan this QR Code
- 15 -
01.08.2023 10:21:26 01.08.2023 10:21:26