OCEANAIRE OWC Series Engineering, Installation And Service Manual page 18

OWC PROGRAM SETTINGS
Program Parameters are NOT controller default values.
LAC.....................
AAA or - - -.......
CON....................
TO CHECK THE NUMBER OF HOURS ON THE UNIT
1) Disconnect unit power, and reconnect unit power.
2) When "888" appears in display, push and release the arrow down
3) The first set of numbers displayed reads thousands of hours:
02 = 2000, 04 = 4000 hours, 00 means less than 1000 hours.
4) The second set of numbers read hours directly:
58 = 58 hours. 742 = 742 hours.
6) Add the 2 number sets together to get total hours.
01 and 59 = 1059 hours.
TOTAL HOURS REPRESENTS COMPRESSOR "RUN" TIME
MODEL
OWC12
OWC18
OWC24
OWC36
OWC60
NOTICE
They are OceanAire Factory Settings
DISPLAY FAULTS
Low AC line power
Failed Air Sensor (unit will not run)
Failed Condensate Pump/Over-Flow Alarm
High Pressure Cut-Out—Low/interrupted condenser water
supply. Correct problem, and re-set unit at HP RESET
CODE SETTINGS
P1 = 65, P2 = 45
P1 = 80, P2 = 50
P1 = 70, P2 = 50
P1 = 85, P2 = 40
P1 = 85, P2 = 45
03 and 486 = 3486 hours.
16
button