Keyboard Stand Assembly - Yamaha Clavinova CLP-955 Owner's Manual

A
A
A
A:
Legs
48
CLP-955
Assembly Parts
B
B:
Pedal box

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the
correct direction. Please assemble in accordance with the sequence
given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of
incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each
unit.
• The entire package must be turned over during assembly, so select
an area that is large enough for the unpacking and assembly opera-
tion.
Have a Phillips-head (+) screwdriver ready.
Open the carton and remove the parts from the upper
level.
The parts shown in the "Assembly Parts" illustration will
be used. Follow the assembly instructions and select the
parts as needed.
• A bench may be supplied or optional, depending on
NOTE
the location in which the instrument was purchased.
• After assembly is complete, keep the wrench for future
maintenance.
Wrench
Cord holders
1
x 3
10 x 60mm bolts
2
x 3
Spring Washers
3
x 3
Washers
4
x 4
5 x 20mm screws
AC power cord