Troubleshooting Guide; Maintenance; Product Service - Technics SH-DJ1200 Operating Instructions Manual

12
Troubleshooting Guide
Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your part may eliminate the problem and restore proper operation.
If you are in doubt about some of the check points, or if the rernedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
Un U.S.A. consult MSC Authorized Servicenters for detailed instructions or call 1-800-545-2672 for the address of an authorized factory
servicenter.)
Has the power plug been disconnected? Connect the power plug securely.
Has the input selector control been set to another Check the source and set the control to the proper
source? position.
Have any of the units been wrongly connected? Connect the units properly.
No sound even when power
is supplied.
Is the master level control or another volume level Adjust the volume level controls correctly.
control at the MIN position?
Left and right sound is Have any of the units been connected with the left Connect the channels correctly.
reversed. and right channels reversed?
Low hum or buzz is heard Is there a fluorescent light or other electrical Place the fluorescent light, other appliances or their
during play. appliance or its power cord near any of the power cords as far away from the audio mixer as
connecting cords? possible.
Has the turntabie's grounding wire been Connect the grounding wire securely.
disconnected?
Is one of the faders worn? Replace with a new fader. (Refer to the Slide
Volume Replacement instructions provided
separately.)
Fader (slide volume
control) fails to move
smoothly.
Maintenance
Wipe the unit with a soft cloth. To remove stubborn dirt, wipe with * Do not use alcohol or paint thinners.
cloth moistened with water or soapy water, and then remove the e When using a chemically treated cleaning cloth, refer to the instruc-
remaining moisture using a dry cloth. tions accompanying it.
Product Service
Do not attempt to remove the cover(s) or repair the unit
yourself. Refer servicing to qualified personnel only.
The servicer will require all components to service your sys-
tem. Therefore, should service ever be necessary, be sure to
bring the entire system.
Product information
For product service, product information or assistance with
product operation, refer to the servicenter directory.
Matsushita Consumer Electronics Panasonic Sales Company, А Matsushita Electric of Canada
Company, Division of Matsushita Division of Matsushita Electric of Limited
Electric Corporation of America Puerto Rico, inc. ("PSC") 5770 Ambler Drive,
One Panasonic Way Secaucus, Ave. 65 de Infantería, Km. 9.5 Mississauga, Ontario
New Jersey 07094 San Gabriel Industrial Park, Carolina, L4W 2T3
Puerto Rico 00985