Advertisement
Quick Links
Advertisement
Related Manuals for USX-MOUNT WML016-24K-01
Summary of Contents for USX-MOUNT WML016-24K-01
- Page 1 47-90" Full Motion TV Wall Mount Model: WML016-24K-01 PRODUCT GUIDE...
- Page 2 DIMENSIONS: TV INTERFACE: SIDE VIEW-RETRACTED: 679mm 435mm/638mm MAX:600mm MIN:200mm 420mm +5° 277.4mm MAX: 400mm 165mm MIN: -15° 100mm 64mm SIDE VIEW-EXTENED: TOP VIEW: +45°/-45° 422mm Congratulations on your latest purchase.Follow these simple instructions and you'll have your TV mounted in no time. Supports most 47 in - 90 in (119.38 cm - 228.60 cm) TVs Maximum Weight Capacity: 120 lbs(54.5 kg) Supports VESA Sizes up to 600mmx400mm...
-
Page 3: Safety Warning
SAFETY WARNING: 1.Never let children climb on product or play with product. 2.Do not sit or stand on product. 3.Do not fasten a TV that is heavier than the recommended load rating to the mount. 4.Using suitable concrete wall or wood stud wall. 5.Improper installation may cause property damage and/or personal injury, so the installation must be done by two qualified contractors. - Page 4 Wall mounting and TV bracket assembly hardware: F--Lag bolt G-- Anchor H--M5X10 screw I--M6X16 screw J--M6X8 screw 4pcs 4pcs 4pcs 8pcs 2pcs K--Allen key L--Bubble Level TV mounting hardware: a--M4x12 screw b--M6x12 screw c--M8x25 screw d--M4x30 screw e--M6x35 screw f--M8X45 screw 4 pcs 4 pcs 4 pcs...
- Page 5 Step 2 : Install wall plate on the wall. For concrete wall: Hold hanging template against wall at desired position on concrete wall, then using a pencil mark 4 hole locations. Then drill holes according pencil marks using 3/8" size drill bit to a depth of 2.5". Please remove the hanging template on the surface of concrete wall when assembling mount on the concrete wall.
- Page 6 24" Wood Studs 7/32" Hanging template Stud Figure 3 (keep the wall plate level) finder Step 3 : Assemble extension arms (B,C) as picture shows, align the extension arm holes with the wall plate unit, then fasten them with screws (J) using allen key (K).(Figure 4) Figure 4 Step 4: Attach end support (D) onto arm extensions (B,C) using screwdriver and...
- Page 7 Step 5 Attach bracket (E) to the back of TV, choose corresponding screw, washer, spacers to fix the holes of TV rear. (Figure 6) CAUTION : Using incorrect spacer s may damage your TV. a/b/c d/e/f g/h/i/j Choose suitable screws, Choose suitable screws washers and spacers.
- Page 8 Step 7 Make sure the TV unit is horizontal, you can adjust the TV plate a little bit (+4/-4 degrees) to level the TV, by loosening or tightening (4) leveling screws with Allen key (K). When it is at your desired position, tighten the 4 leveling screws.
- Page 9 Step 9 Manage TV cables orderly and guide them through the velcros. (Figure 10) Figure 10 PAY EXTRA CARE AND ATTENTION WHEN YOU FASTEN TWO TV BRACKETS TO THE BACK PANEL OF TV IN STEP 5 . MAKE SURE THE APPROPRIATE MOUNT HARDWARE IS BEING USED PROPERLY .
Need help?
Do you have a question about the WML016-24K-01 and is the answer not in the manual?
Questions and answers